The NX3L1T53 provides one low-ohmic single-pole double-throw analog switch, suitable for use as an analog or digital multiplexer/demultiplexer. It has a digital select input (S), two independent inputs/outputs (Y0, Y1), a common input/output (Z) and an active LOW enable input (E). When pin E is HIGH, the switch is turned off. Schmitt-trigger action at the se.
I Wide supply voltage range from 1.4 V to 4.3 V I Very low ON resistance (peak): N 1.6 Ω (typical) at VCC = 1.4 V N 1.0 Ω (typical) at VCC = 1.65 V N 0.55 Ω (typical) at VCC = 2.3 V N 0.50 Ω (typical) at VCC = 2.7 V N 0.50 Ω (typical) at VCC = 4.3 V I Break-before-make switching I High noise immunity I ESD protection: N HBM JESD22-A114E Class 3A exceeds 7500 V N MM JESD22-A115-A exceeds 200 V N CDM AEC-Q100-011 revision B exceeds 1000 V I CMOS low-power consumption I Latch-up performance exceeds 100 mA per JESD 78 Class II Level A I 1.8 V control logic at VCC = 3.6 V I Control input accepts vo.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NX3L1T5157 |
NXP Semiconductors |
Low-ohmic single-pole double-throw switch | |
2 | NX3L1T3157 |
NXP Semiconductors |
Low-ohmic single-pole double-throw analog switch | |
3 | NX3L1T384 |
NXP |
Single-pole Single-throw Analog Switch | |
4 | NX3L1T66 |
NXP |
Low-ohmic Single-pole Single-throw Analog Switch | |
5 | NX3L1G3157 |
NXP Semiconductors |
Low-ohmic single-pole double-throw analog switch | |
6 | NX3L1G3157-Q100 |
NXP |
Low-ohmic single-pole double-throw analog switch | |
7 | NX3L1G384 |
NXP |
Low-ohmic single-pole single-throw analog switch | |
8 | NX3L1G53 |
NXP |
Low-ohmic Single-pole Double-throw Analog Switch | |
9 | NX3L1G66 |
NXP Semiconductors |
Low-voltage analog switch | |
10 | NX3L1G66-Q100 |
NXP |
Low-ohmic single-pole single-throw analog switch | |
11 | NX3L2267 |
NXP |
Low-ohmic dual single-pole double-throw analog switch | |
12 | NX3L2267S |
NXP |
Low-ohmic dual single-pole double-throw analog switch |