The NX3L1G66 is a low-ohmic single-pole single-throw analog switch. It has two input/output terminals (Y and Z) and an active HIGH enable input pin (E). When E is LOW, the analog switch is turned off. Schmitt trigger action at the enable input (E) makes the circuit tolerant to slower input rise and fall times. The NX3L1G66 allows signals with amplitude up to.
Wide supply voltage range from 1.4 V to 4.3 V
Very low ON resistance (peak):
1.6 (typical) at VCC = 1.4 V 1.0 (typical) at VCC = 1.65 V 0.55 (typical) at VCC = 2.3 V 0.50 (typical) at VCC = 2.7 V 0.50 (typical) at VCC = 4.3 V
High noise immunity
ESD protection: HBM JESD22-A114F Class 3A exceeds 7500 V MM JESD22-A115-A exceeds 200 V CDM AEC-Q100-011 revision B exceeds 1000 V IEC61000-4-2 contact discharge exceeds 4000 V for switch ports
CMOS low-power consumption
Latch-up performance exceeds 100 mA per JESD 78 Class II Level A
Direct interface with TTL .
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NX3L1G66-Q100 |
NXP |
Low-ohmic single-pole single-throw analog switch | |
2 | NX3L1G3157 |
NXP Semiconductors |
Low-ohmic single-pole double-throw analog switch | |
3 | NX3L1G3157-Q100 |
NXP |
Low-ohmic single-pole double-throw analog switch | |
4 | NX3L1G384 |
NXP |
Low-ohmic single-pole single-throw analog switch | |
5 | NX3L1G53 |
NXP |
Low-ohmic Single-pole Double-throw Analog Switch | |
6 | NX3L1T3157 |
NXP Semiconductors |
Low-ohmic single-pole double-throw analog switch | |
7 | NX3L1T384 |
NXP |
Single-pole Single-throw Analog Switch | |
8 | NX3L1T5157 |
NXP Semiconductors |
Low-ohmic single-pole double-throw switch | |
9 | NX3L1T53 |
NXP |
Low-ohmic Single-pole Double-throw Analog Switch | |
10 | NX3L1T66 |
NXP |
Low-ohmic Single-pole Single-throw Analog Switch | |
11 | NX3L2267 |
NXP |
Low-ohmic dual single-pole double-throw analog switch | |
12 | NX3L2267S |
NXP |
Low-ohmic dual single-pole double-throw analog switch |