The NX20P5090 is an advanced 5 A unidirectional power switch for USB PD. It includes under voltage lockout, over voltage lockout, reverse current protection and over-temperature protection circuits. It is designed to automatically isolate the power switch terminals when a fault condition occurs. Both VBUS and VINT pins have 29 V tolerance in shutdown mode. T.
Wide supply voltage range from 2.5 V to 20 V
ISW maximum 5 A continuous current
29 V tolerance on both VBUS and VINT pin
30 m (typical) Low ON resistance
Adjustable VBUS over voltage protection
Built in slew rate control for inrush current limit
All time two level reverse-current protection
Protection circuitry
Over-Temperature Protection Over-Voltage Protection Under-Voltage Lockout Reverse Current Protection
Surge protection: IEC61000-4-5 exceeds ±90 V on VBUS without capacitor IEC61000-4-5 exceeds ±100 V on VBUS with 22 uF capacitor
NXP Semiconductors
NX20P5.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NX20P0407 |
NXP |
CC and SBU Protection | |
2 | NX20P0408 |
NXP |
USB D+/D- protection | |
3 | NX20P0477 |
NXP |
USB Type-C CC smart protection | |
4 | NX20P3483UK |
NXP |
high voltage sink/source combo switch | |
5 | NX2016SF |
NDK |
Crystal Units | |
6 | NX2020N2 |
NXP |
N-channel Trench MOSFET | |
7 | NX2020P1 |
NXP |
single P-channel Trench MOSFET | |
8 | NX2113 |
Microsemi |
300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER | |
9 | NX2113A |
Microsemi |
300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER | |
10 | NX2114 |
Microsemi |
300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER | |
11 | NX2114 |
NEXSEM |
300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER | |
12 | NX2114A |
Microsemi |
300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER |