Each of these data selectors/multiplexers contains inverters and drivers to supply full binary decoding data selection to the AND-OR gates. Separate strobe inputs (G) are provided for each of the two four-line sections. 3 2 1 20 19 1C1 4 18 2C1 1C0 5 17 2C2 NC 6 16 NC A7 15 2C3 B8 14 2G 9 10 11 12 13 1Y GND NC 2Y 1G The 3-state outputs can inte.
gates. Separate strobe inputs (G) are provided for each of the two four-line sections. 3 2 1 20 19 1C1 4 18 2C1 1C0 5 17 2C2 NC 6 16 NC A7 15 2C3 B8 14 2G 9 10 11 12 13 1Y GND NC 2Y 1G The 3-state outputs can interface with and drive data lines of bus-organized systems. With all but one of the common outputs disabled (at a high-impedance state), the low-impedance of the single enabled output will drive the bus line to a high or low logic level. Each output has its own strobe (G). The output is disabled when its strobe is high. The 54ACT11353 is characterized for operation over .
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | 74ACT11352 |
Texas Instruments |
DUAL 4-LINE TO 1-LINE DATA SELECTOR/MULTIPLEXER | |
2 | 74ACT11373 |
Texas Instruments |
OCTAL TRANSPARENT D-TYPE LATCH | |
3 | 74ACT11374 |
Texas Instruments |
OCTAL EDGE-TRIGGERED D-TYPE FLIP-FLOP | |
4 | 74ACT11377 |
Philips |
OCTAL D-TYPE FLIP-FLOP | |
5 | 74ACT11377 |
Texas Instruments |
OCTAL D-TYPE FLIP-FLOP | |
6 | 74ACT11378 |
Texas Instruments |
HEX D-TYPE FLIP FLOP | |
7 | 74ACT11379 |
Texas Instruments |
QUAD D-TYPE FLIP FLOP | |
8 | 74ACT11 |
STMicroelectronics |
TRIPLE 3-INPUT AND GATE | |
9 | 74ACT11000 |
Texas Instruments |
QUADRUPLE 2-INPUT POSITIVE-NAND GATES | |
10 | 74ACT11002 |
Texas Instruments |
QUADRUPLE 2-INPUT POSITIVE-NOR GATES | |
11 | 74ACT11004 |
Texas Instruments |
HEX INVERTER | |
12 | 74ACT11008 |
Texas Instruments |
QUADRUPLE 2-INPUT POSITIVE-AND GATE |