| No. | Partie # | Fabricant | Description | Fiche Technique |
|---|---|---|---|---|
|
|
|
Dallas Semiconductor |
(DS2501 / DS2502) Add Only Memory |
|
|
|
|
Dallas Semiconducotr |
Quad E1 Framer § § § § § Four E1 (CEPT or PCM-30) /ISDN-PRI framing transceivers All four framers are fully independent; transmit and receive sections of each framer are fully independent Frames to FAS, CAS, CCS, and CRC4 formats 8-bit parallel control port that ca |
|
|
|
|
Dallas Semiconducotr |
MTTF is frequently used interchangeably with MTBF rating: The Arrhenius model will be used to determine the acceleration factor for failure mechanisms that are temperature accelerated. AfT = exp((Ea/k)*(1/Tu - 1/Ts)) = tu/ts AfT = Acceleration factor due to Temperature tu = Time at use temperature ( |
|
|
|
|
Dallas Semiconducotr |
T1/CEPT Elastic Store • • • • • • Rate buffer for T1 and CEPT transmission systems Synchronizes loop –timed and system timed data streams on frame boundaries Ideal for T1 (1.544 MHz) to CEPT (2.048 MHz), CEPT to T1 interfaces Supports parallel and serial backplanes Buffer |
|
|
|
|
Dallas Semiconducotr |
T1 Line Monitor § § Performs framing and monitoring functions Supports Superframe and Extended Superframe formats Four onboard error counters – 16-bit bipolar violation – 8-bit CRC – 8-bit OOF – 8-bit frame bit error Indication of the following – yellow and blue ala |
|
|
|
|
Dallas Semiconducotr |
Battery Identification Chip with Time/Temperature Histogram Provides unique ID number to battery packs Eliminates thermistors by sensing battery temperature on-chip Elapsed time counter provides indication of battery usage/storage time Time/temperature histogram function provides essential information for det |
|
|
|
|
Dallas Semiconducotr |
UniqueWare Add-Only Memory § 1024 bits, 16 kbits or 64 kbits Electrically Programmable Read Only Memory (EPROM) communicates with the economy of one signal plus ground § Unique, factory-lasered and tested 64-bit registration number (8-bit family code, 36-bit serialization, 12- |
|
|
|
|
Dallas Semiconductor |
SHA-1 Battery Pack Authentication IC Secure Challenge and Response Authentication Using the SHA-1 Algorithm ® Directly Powered by the Dallas 1-Wire Interface with 16kpbs Standard and 143kpbs Overdrive Communication Modes Unique 64-Bit Serial Number Thermistor Multiplexer Operates with V |
|
|
|
|
Dallas Semiconducotr |
G.726 ADPCM Processor § § Compresses/expands 64kbps PCM voice to/from either 32kbps, 24kbps, or 16kbps Dual fully independent channel architecture; device can be programmed to perform either: - two expansions - two compressions - one expansion and one compression Intercon |
|
|
|
|
Dallas Semiconducotr |
Plug and Play SCSI Terminator Fully compliant with SCSI-1, Fast SCSI and Ultra SCSI Compatible with Plug and Play SCSI Profile Functional drop in replacement for the DS2109 Complementary part to DS21T07 for wide SCSI Provides active termination for 18 signal lines 2% tolerance on |
|
|
|
|
Dallas Semiconducotr |
256-Bit 1-Wire EEPROM § 256-bit Electrically Erasable Programmable Read Only Memory (EEPROM) plus 64-bit one-time programmable application register § Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number + 8-bit CRC tester |
|
|
|
|
Dallas Semiconducotr |
16-kbit Add-Only Memory 16384 bits Electrically Programmable Read Only Memory (EPROM) communicates with the economy of one signal plus ground Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number + 8-bit CRC tester) assures |
|
|
|
|
Dallas |
512 x 9 FIFO Chip |
|
|
|
|
Dallas Semiconducotr |
3.3V E1/T1/J1 Quad Line Interface § § § § § § § § § § § § § § § § § § § § § Four Complete E1, T1, or J1 LIUs Supports Long- and Short-Haul Trunks Internal Software-Selectable Receive-Side Termination for 75W/100W/120W 3.3V Power Supply 32-Bit or 128-Bit Crystal-Less Jitter Attenuator |
|
|
|
|
Dallas Semiconducotr |
T1/E1/J1 Single-Chip Transceiver TDM/UTOPIA II Interface Complete T1/DS1/ISDN-PRI/J1 Transceiver Functionality Complete E1 (CEPT) PCM-30/ISDN-PRI Transceiver Functionality Long-Haul and Short-Haul Line Interface for Clock/Data Recovery and Waveshaping CMI Coder/Decoder for Optical I/F Crystal-Less Jitter A |
|
|
|
|
Dallas Semiconducotr |
3.3V/5V Clock Rate Adapter § § § § § § § § Direct Replacement for LXP610SE Converts E-Carrier Clock Rates to T-Carrier Clock Rates Converts T-Carrier Clock Rates to E-Carrier Clock Rates 3.3V or 5V Supply Low Jitter Output Multiple Output Clocks Synchronized to Input Clock 8kH |
|
|
|
|
Dallas Semiconducotr |
CEPT Primary Rate Transceiver Single chip primary rate transceiver meets CCITT standards G.704, G.706 and G.732 Supports new CRC4-based framing standards and CAS and CCS signaling standards Simple serial interface used for device configuration and control in processor mode Hardwa |
|
|
|
|
Dallas Semiconducotr |
5V E1/T1/J1 Line Interface § § § § § Complete E1, T1, or J1 line interface unit (LIU) Supports both long- and short-haul trunks Internal software-selectable receive-side termination for 75Ω/100Ω/120W 5V power supply 32-bit or 128-bit crystal-less jitter attenuator requires onl |
|
|
|
|
Maxim Integrated Products |
Dallas Semiconductor will be used to determine the acceleration factor for failure mechanisms that are temperature accelerated. AfT = exp((Ea/k)*(1/Tu - 1/Ts)) = tu/ts AfT = Acceleration factor due to Temperature tu = Time at use temperature (e.g. 55°C) ts = Time at stre |
|
|
|
|
Dallas Semiconducotr |
EconoRAM PACKAGE OUTLINE TO –92 • Low –cost, general –purpose, 256 –bit memory – DS2223 has 256 –bit SRAM – DS2224 has 32 –bit ROM, 224 –bit SRAM • Reduces single pin control, address and data interface to a • Each DS2224 32 –bit ROM is factory –lasered with a un |
|