The SP3485 device is a 3.3V low power half-duplex transceiver that meets the specifications of the RS-485 and RS-422 serial protocols. This device is pin-to-pin compatible with the MaxLinear SP481, SP483 and SP485 devices as well as popular industry standards. The SP3485 can meet the electrical specifications of the RS-485 and RS422 serial protocols up to 10.
■
■ RS-485 and RS-422 transceiver
■
■ Operates from a single 3.3V supply
■
■ Interoperable with 5.0V logic
■
■ Driver/receiver enable
■
■ -7V to +12V common-mode input voltage
range
■
■ Allows up to 32 transceivers on the serial
bus
■
■ Compatibility with industry standard 75176
pinout
■
■ Driver output short-circuit protection
Ordering Information - Back Page
Block Diagram
RO 1 RE 2 DE 3 DI 4
R
8 VCC
7B
6A
D
5 GND
SP3485
216DSR00
1
Rev. 2.0.2
SP3485
Absolute Maximum Ratings
These are stress ratings only and functional operation of the device at these ratings or any other above those in.
The SP3485 device is a +3.3V low power half-duplex transceiver that meets the specifications of the RS-485 and RS-422 se.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | SP3481 |
Sipex |
+3.3V Low Power Half-Duplex RS-485 Transceivers with 10Mbps Data Rate | |
2 | SP3483 |
MaxLinear |
3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver | |
3 | SP3483 |
Exar |
+3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver | |
4 | SP3483 |
Sipex |
+3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver | |
5 | SP3485E |
UMW |
RS485/RS422 transceiver | |
6 | SP3486 |
Sipex |
+3.3V Low Power Quad RS-485/RS-422 Line Drivers | |
7 | SP3487 |
Sipex |
+3.3V Low Power Quad RS-485/RS-422 Line Drivers | |
8 | SP3488 |
Sipex |
+3.3V Low Power Quad RS-485/RS-422 Line Receivers | |
9 | SP3489 |
Sipex |
+3.3V Low Power Quad RS-485/RS-422 Line Receivers | |
10 | SP3400 |
Littelfuse |
Diode Array | |
11 | SP3401 |
Littelfuse |
18kV Diode Array | |
12 | SP3406 |
SYNC POWER |
600mA Buck Converter |