SP3406 is a high efficiency monolithic synchronous buck regulator using a constant frequency, current mode architecture. The device is available in an adjustable version and fixed output voltages, such as 1.5V,1.8V,etc. Supply current with no load is 30uA and drops to <1uA in shutdown. The 2.5 to 6.5V input voltage range makes the SP3406 ideally suitable for.
High Efficiency: Up to 96%; 1.5MHz Constant Switching Frequency; 600mA Output Current at Vin=3V; Integrated Main Switch and Synchronous Rectifier, No Schottky Diode Required; 2.5 to 6.5V input voltage; Output Voltage as Low as 0.6V; 100% Duty Cycle in Dropout; Quiescent Current: 30uA(input<4.2V); Slope Compensated Current Mode Control for Excellent Line and Load Transient Response; Short Circuit Protection and Thermal Fault Protection; <1uA Shutdown Current; Soft Start; PIN CONFIGURATION ( SOT-23-5L) PART MARKING 2012/11/15 V. 1 Page 1 http://www.Datasheet4U.com SP3406 600mA Buck Convert.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | SP3400 |
Littelfuse |
Diode Array | |
2 | SP3401 |
Littelfuse |
18kV Diode Array | |
3 | SP34063A |
Exar |
1.5A Buck/Boost/Inverting DC-DC Regulator | |
4 | SP34063A |
Sipex Corporation |
1.5A Buck/Boost/Inverting DC-DC Switching Regulator | |
5 | SP3420 |
Littelfuse |
6A Diode Array | |
6 | SP3422 |
Littelfuse |
TVS Diode Arrays | |
7 | SP3481 |
Sipex |
+3.3V Low Power Half-Duplex RS-485 Transceivers with 10Mbps Data Rate | |
8 | SP3483 |
MaxLinear |
3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver | |
9 | SP3483 |
Exar |
+3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver | |
10 | SP3483 |
Sipex |
+3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver | |
11 | SP3485 |
MaxLinear |
3.3V Low Power Half-Duplex RS-485 Transceiver | |
12 | SP3485 |
Exar |
+3.3V Low Power Half-Duplex RS-485 Transceiver |