Pin # Pin Name Function 1 GND1 Ground of the 1st LDO 2 En1 Enables the 1st LDO 3 GND2 Ground of the 2nd LDO 4 En2 Enables the 2nd LDO 5 Vcc2 2nd LDO Vcc pin 6 Vout2 Shuts or wakes−up the IC 7 Vcc1 1st LDO Vcc pin 8 Vout1 Delivers the output voltage Description A 900 mV level on this pin is sufficient to start this LDO. A 150 mV shut.
• Nominal Output Current of 80 mA with a 100 mA Peak Capability
• Ultra−Low Noise: 150 nV/√Hz @ 100 Hz, 40 mVRMS
100 Hz−100 kHz Typical, Iout = 60 mA, Co = 1.0 mF
• Fast Response Time from OFF to ON: 40 ms Typical
• Ready for 1.0 V Platforms: ON with a 900 mV High Level
• Typical Dropout of 90 mV @ 30 mA, 160 mV @ 80 mA
• Ripple Rejection: 70 dB @ 1.0 kHz
• 1.5% Output Precision @ 25°C
• Thermal Shutdown
• Vout Available at 2.5 V, 2.8 V, and 3.0 V
• Separate Dice for Each Regulator Provides Maximum Isolation
Between Regulators
• Operating Range from −40 to +85°C
• Pb−Free Packages are Availabl.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | MC33761 |
ON Semiconductor |
Ultra Low-Noise Low Dropout Voltage Regulator | |
2 | MC33765 |
ON Semiconductor |
Very Low Dropout/Ultra Low Noise 5 Outputs Voltage Regulator | |
3 | MC33702 |
Motorola |
Microprocessor Power Supply | |
4 | MC3370P |
Motorola |
Zero Voltage Switch | |
5 | MC3371 |
Motorola |
(MC3372) LOW POWER FM IF | |
6 | MC3371 |
LANSDALE Semiconductor |
Low Power Narrowband FM IF | |
7 | MC3372 |
LANSDALE Semiconductor |
Low Power Narrowband FM IF | |
8 | MC3372 |
Motorola |
Low Power Narrowband FM IF | |
9 | MC3373 |
Motorola |
Remote Control Amplifier/Detector | |
10 | MC33730 |
NXP |
Switch Mode Power-Supply | |
11 | MC3374 |
Motorola |
LOW VOLTAGE SINGLE CONVERSION FM RECEIVER | |
12 | MC33742 |
Motorola |
System Basis Chip (SBC) with Enhanced High-Speed CAN Transceiver |