OPERATING CONDITIONS VCC = 4.0 Vdc, RFIn = 100 µV, fmod = 1.0 kHz, fdev = 3.0 kHz. MC3371 at fRF = 10.7 MHz (see Figure 11). Pin 1 Symbol OSC1 Internal Equivalent Circuit Description The base of the Colpitts oscillator. Use a high impedance and low capacitance probe or a “sniffer” to view the wave– form without altering the frequency. Typical level is 450 mV.
ting Voltage Sensitivity of
–3.0 dB Low Drain Current: ICC = 3.2 mA, @ VCC = 4.0 V, Squelch Off Minimal Drain Current Increase When Squelched Signal Strength Indicator: 60 dB Dynamic Range Mixer Operating Frequency Up to 100 MHz Fewer External Parts Required than Earlier Devices
16 1
D SUFFIX PLASTIC PACKAGE CASE 751B (SO
–16)
16
MAXIMUM RATINGS
Rating Power Supply Voltage RF Input Voltage (VCC Detector Input Voltage Squelch Input Voltage (VCC 4.0 Vdc) Pin Symbol VCC(max) V16 V8 V12 V14 l14 TJ Tstg Value 10 1.0 1.0 6.0
–0.7 to 10 50 150
–65 to +150 Unit Vdc Vrms Vpp Vdc Vpk mA °C °C 4 16 8 1.
OPERATING CONDITIONS VCC = 4.0 Vdc, RFIn = 100 µV, fmod = 1.0 kHz, fdev = 3.0 kHz. ML3371 at f RF = 10.7 MHz (see Figure.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | MC33702 |
Motorola |
Microprocessor Power Supply | |
2 | MC3370P |
Motorola |
Zero Voltage Switch | |
3 | MC3371 |
Motorola |
(MC3372) LOW POWER FM IF | |
4 | MC3371 |
LANSDALE Semiconductor |
Low Power Narrowband FM IF | |
5 | MC3373 |
Motorola |
Remote Control Amplifier/Detector | |
6 | MC33730 |
NXP |
Switch Mode Power-Supply | |
7 | MC3374 |
Motorola |
LOW VOLTAGE SINGLE CONVERSION FM RECEIVER | |
8 | MC33742 |
Motorola |
System Basis Chip (SBC) with Enhanced High-Speed CAN Transceiver | |
9 | MC33761 |
ON Semiconductor |
Ultra Low-Noise Low Dropout Voltage Regulator | |
10 | MC33762 |
ON Semiconductor |
Dual Ultra Low-Noise Low Dropout Voltage Regulator | |
11 | MC33765 |
ON Semiconductor |
Very Low Dropout/Ultra Low Noise 5 Outputs Voltage Regulator | |
12 | MC33771BSA1AE |
NXP |
Battery cell controller |