.............. 1 3 Pinout ............. 2 4 Code example Arduino ...........
2,5kHz. The active Buzzer-module doesn't need a square wave, unlike the passiv module (KY-006), to create a sound. If it gets a minimum Voltage of 3.3V at its signal pin, the buzzer will create the square wave by itself. Export: 16.06.2017 Copyright by Joy-IT - Published under CC BY-NC-SA 3.0 Page 51 of 214 KY-012 Active Piezo-Buzzer module Pinout Code example Arduino In this example, you will see how the buzzer will be ON for 4 seconds and then will be OFF for 2 seconds. int Buzzer = 13; void setup () { pinMode (Buzzer, OUTPUT); // Output pin initialization for the buzzer } void loop (.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | KY-010 |
Joy-IT |
Light barrier-module | |
2 | KY-011 |
Joy-IT |
2-Color (Red+Green) 5mm LED module | |
3 | KY-013 |
Joy-IT |
Temperature-Sensor module | |
4 | KY-015 |
Joy-IT |
Combi-Sensor Temperature + Humidity | |
5 | KY-016 |
Joy-IT |
RGB 5mm LED module | |
6 | KY-017 |
Joy-IT |
Tilt switch module | |
7 | KY-018 |
Joy-IT |
Photoresistor module | |
8 | KY-019 |
Joy-IT |
5V Relais module | |
9 | KY-001 |
Joy-IT |
Temperature sensor module | |
10 | KY-002 |
Joy-IT |
Vibration-switch module | |
11 | KY-003 |
Joy-IT |
Hall Magnetic Field Sensor | |
12 | KY-004 |
Joy-IT |
Button-module |