The ISO1042 device is a galvanically-isolated controller area network (CAN) transceiver that meets the specifications of the ISO11898-2 (2016) standard. The ISO1042 device offers ±70-V DC bus fault protection and ±30-V common-mode voltage range. The device supports up to 5-Mbps data rate in CAN FD mode allowing much faster transfer of payload compared to cla.
•1 Meets the ISO 11898-2:2016 physical layer standard
• Supports classic CAN up to 1 Mbps and FD (Flexible Data Rate) up to 5 Mbps
• Low loop delay: 152 ns
• Protection features
– DC bus fault protection voltage: ±70 V
– HBM ESD tolerance on bus pins: ±16 kV
– Driver Dominant Time Out (TXD DTO)
– Undervoltage protection on VCC1 and VCC2
• Common-Mode Voltage Range: ±30 V
• Ideal passive, high impedance bus terminals when unpowered
• High CMTI: 100 kV/µs
• VCC1 voltage range: 1.71 V to 5.5 V
– Supports 1.8-V, 2.5-V, 3.3-V and 5.0-V logic
interface to the CAN controller
• VCC2 Voltage Range: 4.5.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | ISO1042-Q1 |
Texas Instruments |
Automotive Isolated CAN Transceiver | |
2 | ISO1044 |
Texas Instruments |
Isolated CAN FD Transceiver | |
3 | ISO100 |
Burr-Brown Corporation |
Optically-Coupled Linear ISOLATION AMPLIFIER | |
4 | ISO1002 |
YUAN |
Small Signal Amplifier | |
5 | ISO1003-xx-x |
YUAN |
Two Wires 4-20mA Isolated Signal Transmitter | |
6 | ISO102 |
Burr-Brown Corporation |
SIGNAL ISOLATION BUFFER AMPLIFIERS | |
7 | ISO103 |
Burr-Brown Corporation |
Low-Cost/ Internally Powered ISOLATION AMPLIFIER | |
8 | ISO1050 |
Texas Instruments |
CAN Transceiver | |
9 | ISO106 |
Burr-Brown Corporation |
SIGNAL ISOLATION BUFFER AMPLIFIERS | |
10 | ISO107 |
Burr-Brown Corporation |
High-Voltage/ Internally Powered ISOLATION AMPLIFIER | |
11 | ISO113 |
Burr-Brown Corporation |
Low-Cost/ High-Voltage/ Internally Powered OUTPUT ISOLATION AMPLIFIER | |
12 | ISO1176 |
Texas Instruments |
RS-485 Profibus Transceiver |