The DLPA2000 is a dedicated PMIC/RGB LED/lamp driver for the DLP2010 and DLP2010NIR digital micromirror devices (DMD) when used with a DLPC3430, DLPC3435, or DLPC150 digital controller. For reliable operation of these chipsets, it is mandatory to use the DLPA2000. Device Information(1) PART NUMBER PACKAGE BODY SIZE (NOM) DLPA2000 DSBGA (56) 3.28 mm × 3.
•1 High Efficiency RGB LED/Lamp Driver with BuckBoost DC-to-DC Converter, DMD Supplies, DPP Core Supply, 1.8-V Load Switch, and Measurement System in a Small Chip-Scale Package
• Three Low-Impedance (30 mΩ Typical at 27°C) MOSFET Switches for Channel Selection
• Independent, 10-Bit Current Control per Channel
• 750-mA Max LED Current for DLPA2000
Embedded Applications
• On-Chip Motor Driver
• DMD Regulators
– Requires Only a Single Inductor
– VOFS: 10 V
– VBIAS: 18 V
– VRST:
–14 V
– Passive Discharge to GND When Disabled
• DPP 1.1-V Core Supply
– Synchronous Step-Down Converter with
Integrated.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | DLPA2005 |
Texas Instruments |
Power Management and LED/Lamp Driver | |
2 | DLPA004 |
Diodes |
DATA BUS TRANSIENT SUPPRESSOR | |
3 | DLPA006 |
Diodes Incorporated |
DATA BUS TRANSIENT SUPPRESSOR/THREE PHASE FULL WAVE BRIDGE RECTIFIER | |
4 | DLPA100 |
Texas Instruments |
Power Management and Motor Driver | |
5 | DLPA1000 |
Texas Instruments |
Power Management and LED Driver | |
6 | DLPA300 |
Texas Instruments |
DLP Digital Micromirror Driver | |
7 | DLPA3000 |
Texas Instruments |
PMIC and High-Current LED Driver | |
8 | DLPA3005 |
Texas Instruments |
PMIC and High-Current LED Driver | |
9 | DLPA4000 |
Texas Instruments |
PMIC and High-Current LED Driver | |
10 | DLP-IO8-G |
DLP Design |
USB-BASED 8-CHANNEL DATA ACQUISITION MODULE | |
11 | DLP05LC |
Diodes Incorporated |
LOW CAPACITANCE UNIDIRECTIONAL TVS | |
12 | DLP0NSA150HL2 |
Murata |
Chip Common Mode Choke Coil |