The bq2014H NiCd/NiMH Gas Gauge IC is intended for batterypack or in-system installation to maintain an accurate record of available battery capacity. The IC monitors a voltage drop across a sense resistor connected in series between the negative battery terminal and ground to determine charge and discharge activity of the battery. Compensations for battery .
➤ Accurate measurement of available capacity in NiCd or NiMH batteries ➤ Low-cost battery management so- lution for pack integration - As little as 1 2 square inch of PCB for complete circuit - Low operating current (120µA typical) - Less than 100nA of data retention current ➤ High-speed (5kb/s) single-wire communication interface (HDQ bus) for critical battery parameters ➤ Communication with an external charge controller such as the bq2004 ➤ Direct drive of remaining capacity LEDs ➤ Automatic rate and temperature compensation of measurements ➤ 16-pin narrow SOIC General D.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | BQ2014 |
UNITRODE |
Gas Gauge | |
2 | BQ2010 |
UNITRODE |
Gas Gauge IC | |
3 | BQ2011 |
UNITRODE |
Gas Gauge IC | |
4 | BQ2011K |
UNITRODE |
Gas Gauge IC | |
5 | BQ2012 |
UNITRODE |
Gas Gauge IC | |
6 | BQ2013H |
Benchmarq |
Gas Gauge IC | |
7 | bq2016 |
Texas Instruments |
GAS GAUGE | |
8 | bq2018 |
Benchmarq |
Power Minder | |
9 | BQ2019 |
Texas Instruments |
Advanced Battery Monitor | |
10 | BQ2000 |
Texas Instruments |
Programmable Multi-Chemistry Fast-Charge Management | |
11 | BQ2000T |
Texas Instruments |
Programmable Multi-Chemistry Fast-Charge Management | |
12 | BQ2001-7R |
Power-One |
60...132 Watt DC-DC Converters |