The bq2013H Gas Gauge IC is intended for battery-pack installation to maintain an accurate record of a battery’s available charge. The IC monitors a voltage drop across a sense resistor connected in series between the negative battery terminal and ground to determine charge and discharge activity of the battery. The bq2013H is designed for high cpaacity batt.
➤ Accurate measurement of available charge in rechargeable batteries ➤ Designed for electric assist bicycles and other applications ➤ Measures a wide dynamic current range ➤ Supports NiCd, NiMH or lead acid ➤ Designed for battery pack inte- gration - 120µA typical standby current (self-discharge estimation mode) - Small size enables imple- mentations in as little as 1 2 square inch of PCB ➤ Direct drive of LEDs for capacity display ➤ Automatic charge and selfdischarge compensation using in- ternal temperature sensor ➤ Simple single-wire serial communications port for subassem.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | BQ2010 |
UNITRODE |
Gas Gauge IC | |
2 | BQ2011 |
UNITRODE |
Gas Gauge IC | |
3 | BQ2011K |
UNITRODE |
Gas Gauge IC | |
4 | BQ2012 |
UNITRODE |
Gas Gauge IC | |
5 | BQ2014 |
UNITRODE |
Gas Gauge | |
6 | BQ2014H |
Benchmarq |
Low-Cost NiCd/NiMH Gas Gauge | |
7 | bq2016 |
Texas Instruments |
GAS GAUGE | |
8 | bq2018 |
Benchmarq |
Power Minder | |
9 | BQ2019 |
Texas Instruments |
Advanced Battery Monitor | |
10 | BQ2000 |
Texas Instruments |
Programmable Multi-Chemistry Fast-Charge Management | |
11 | BQ2000T |
Texas Instruments |
Programmable Multi-Chemistry Fast-Charge Management | |
12 | BQ2001-7R |
Power-One |
60...132 Watt DC-DC Converters |