The BL6501 is a low cost, high accuracy, high stability, simple peripheral circuit electrical energy meter IC. The meter based on the BL6501 is intended for using in single-phase, two-wire distribution systems. It can exactly measure the real power in the positive orientation and negative orientation and calculate the energy in the same orientation. The BL65.
High accuracy, less than 0.1% error over a dynamic range of 500 : 1 Exactly measure the real power in the positive orientation and negative orientation, calculate the energy in the same orientation Two current monitors continuously monitor the phase and neutral currents in two-wire distribution systems. Uses the larger of two currents to bill, even during a Fault condition A PGA in the current channel allows using small value shunt and burden resistance The low frequency outputs F1 and F2 can directly drive electromechanical counters and two phase stepper motors and the high frequency output C.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | BL6501A |
SHANGHAI BELLING |
Single Phase Energy Meter IC | |
2 | BL6502 |
SHANGHAI BELLING |
Integrated Oscillator Single Phase Current Sampling Energy Metering IC | |
3 | BL6503 |
SHANGHAI BELLING |
Single Phase Energy Meter IC | |
4 | BL6503E |
BELLING |
Single Phase Energy Meter IC | |
5 | BL6511 |
SHANGHAI BELLING |
Three-phase Active Energy Meter | |
6 | BL6512 |
SHANGHAI BELLING |
With phase-phase metering chip output | |
7 | BL6513 |
SHANGHAI BELLING |
Three-phase Active Energy Meter | |
8 | BL6513C |
SHANGHAI BELLING |
Three-phase four-wire wide-range meter | |
9 | BL6514 |
SHANGHAI BELLING |
Phase active power metering chip | |
10 | BL652 |
Laird |
enable OEMs to add single-mode Bluetooth | |
11 | BL652-SA |
Laird |
enable OEMs to add single-mode Bluetooth | |
12 | BL652-SC |
Laird |
enable OEMs to add single-mode Bluetooth |