The WT6014 is a member of WT60XX microcontroller family. It is specially designed for digital controlled multi-sync monitor. It contains 8-bit CPU, 4K bytes ROM, 128 bytes RAM, 14 PWMs, parallel I/O, SYNC processor, timer, DDC interface (slave mode I2C interface with DDC1), and watch-dog timer. FEATURES * 8-bit 6502 compatible CPU, 4MHz operating frequency .
* 8-bit 6502 compatible CPU, 4MHz operating frequency
* 4096 bytes ROM, 128 bytes SRAM
* 8MHz crystal oscillator
* 14 channels 8-bit/62.5kHz PWM outputs (8 open drain outputs & 6 CMOS outputs)
* Sync signal processor with sync separation, frequency calculation, H/V polarity detection control
* DDC interface supports VESA DDC1/DDC2B standard
* Watch-dog timer (0.524 second)
* Maximum 22 programmable I/O pins
* One 8-bit programmable timer
* One external interrupt request
* Built-in low VDD voltage reset
* Single +5V power supply
PIN ASSIGNMENT
40-Pin PDIP
DA2 DA1 DA0 RESET VDD GND OSCO OSCI PB.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | WT6016 |
ETC |
Digital Monitor Controller | |
2 | WT6018 |
ETC |
Digital Monitor Controller | |
3 | WT6002 |
W2 Technology |
Active Diode Driver IC | |
4 | WT6003 |
W2 Technology |
Active Diode Driver IC | |
5 | WT60P1 |
ETC |
Digital Monitor Controller | |
6 | WT6116 |
ETC |
microcontroller for digital controlled monitor | |
7 | WT6124 |
ETC |
microcontroller for digital controlled monitor | |
8 | WT6132 |
ETC |
microcontroller for digital controlled monitor | |
9 | WT6148 |
Weitrend |
(WT6148 / WT6160) Digital Monitor Controller | |
10 | WT6160 |
Weitrend |
(WT6148 / WT6160) Digital Monitor Controller | |
11 | WT61P4 |
Weltrend |
Embedded Micro Controller | |
12 | WT61P6 |
Weltrend |
Embedded Micro-Controller |