Amplifiers The TDA8589 has a complementary quad audio power amplifier that uses BCDMOS technology. It contains four amplifiers configured in Bridge Tied Load (BTL) to drive speakers for front and rear left and right channels. The I2C-bus allows diagnostic information of each amplifier and its speaker to be read separately. Both front and both rear channel amp.
Amplifiers
• I2C-bus control
• Can drive a 2 Ω load with a battery voltage of up to 16 V
and a 4 Ω load with a battery voltage of up to 18 V
• DC load detection: open, short and present
• AC load (tweeter) detection
• Programmable clip detect 1 % or 3%
• Programmable thermal protection pre-warning
• Independent short-circuit protection per channel
• Low gain line driver mode (20 dB)
• Loss-of-ground and open VP safe
• All outputs protected from short-circuit to ground, to VP,
or across the load
• All pins protected from short-circuit to ground
• Soft thermal-clipping to prevent audio holes
• Lo.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | TDA8589J |
NXP |
I2C Bus Controlled 4 x 45 Watt Power Amplifier and Multiple Voltage Regulator | |
2 | TDA8589xJ |
NXP |
I2C Bus Controlled 4 x 45 Watt Power Amplifier and Multiple Voltage Regulator | |
3 | TDA8580 |
NXP |
Multi-purpose power amplifier | |
4 | TDA8580J |
NXP |
Multi-purpose power amplifier | |
5 | TDA8581 |
NXP |
Multi-purpose high-gain power amplifier | |
6 | TDA8586 |
NXP |
Power amplifier with load detection and auto BTL/SE selection | |
7 | TDA8587J |
NXP |
4 x 25 W BTL power amplifier | |
8 | TDA8588AJ |
Philips |
Power Amplifier and Multiple Voltage Regulator | |
9 | TDA8588BJ |
Philips |
Power Amplifier and Multiple Voltage Regulator | |
10 | TDA8588J |
Philips |
Power Amplifier and Multiple Voltage Regulator | |
11 | TDA8501 |
NXP |
PAL/NTSC encoder | |
12 | TDA8505 |
NXP |
SECAM encoder |