Pin Symbol 1 XIN/VDD VDD Power 2 GND Power 3 XOUT/CLK Output 4 GND Power Functionality Connect to µC GPIO pin XTAL1 set High via firmware[3] Electrical ground CLK output; connect to µC XTAL2 pin (refer to Figure 18 in Application Note section) Electrical GND Top View GND 4 3 XOUT/CLK XIN/VDD 1 2 GND Figure 1. Pin Assignments Notes: 3. A.
◼ No load capacitors required
◼ No motional series resistance (ESR) compensation
◼ No negative resistance testing
◼ Guaranteed oscillator startup under all conditions
◼ One active resonator can drive up to two clock inputs
◼ All-inclusive frequency stability as low as ±20 ppm over
extended temperature range (-55°C to 125°C)
◼ Fundamental frequencies between 115.2 MHz and
137 MHz accurate to 6 decimal places
◼ Industry best G-sensitivity of 0.1 ppb/g
◼ Low power consumption of 4.9 mA typical at 1.8 V
◼ LVCMOS compatible output
◼ Industry-standard packages: 2.5 x 2.0, 3.2 x 2.5 mm x mm
◼ RoHS an.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | SiT1420B |
SiTime |
Active Resonator Drop-In Replacement | |
2 | SiT1421B |
SiTime |
Active Resonator Drop-In Replacement | |
3 | SiT1424B |
SiTime |
Active Resonator Drop-In Replacement | |
4 | SiT1408B |
SiTime |
Active Resonator Drop-In Replacement | |
5 | SiT1409B |
SiTime |
Active Resonator Drop-In Replacement | |
6 | SiT1418B |
SiTime |
Active Resonator Drop-In Replacement | |
7 | SiT1419B |
SiTime |
Active Resonator Drop-In Replacement | |
8 | SIT1040 |
SIT |
1Mbps High Speed CAN transceiver | |
9 | SIT1050 |
SIT |
1Mbps High Speed CAN transceiver | |
10 | SiT1532 |
SiTime |
XTAL Replacement | |
11 | SiT1533 |
SiTime |
Quartz XTAL Replacement | |
12 | SiT1534 |
SiTime |
Programmable Oscillator |