SRF05 Technical Documentation Page 1 of 4 SRF05 - Ultra-Sonic Ranger Technical Specification www.DataSheet4U.com Introduction The SRF05 is an evolutionary step from the SRF04, and has been designed to increase flexibility, increase range, and to reduce costs still further. As such, the SRF05 is fully compatible with the SRF04. Range is increased from 3 me.
5 in this mode. To use this mode, just leave the mode pin unconnected - the SRF05 has an internal pull up resistor on this pin. file://D:shared folders servidorPDFOrganizadaSensoresDistanciaSRF05 Technica... 29/05/2008 PDF created with pdfFactory trial version www.pdffactory.com SRF05 Technical Documentation Page 2 of 4 www.DataSheet4U.com Mode 2 - Single pin for both Trigger and Echo This mode uses a single pin for both Trigger and Echo signals, and is designed to save valuable pins on embedded controllers. To use this mode, connect the mode pin to the 0v Ground pin. The echo signal will.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | SRF005 |
Revolution Education |
ULTRASONIC RANGE SENSOR | |
2 | SRF01 |
ETC |
Ultrasonic range finder | |
3 | SRF02 |
ETC |
Ultrasonic Range Finder | |
4 | SRF02 |
ETC |
Ultrasonic Range Finder Tech | |
5 | SRF04 |
ETC |
Ultrasonic Rangefinger Schematic | |
6 | SRF04 |
Parallax |
Ultrasonic Range Finger Application Note | |
7 | SRF04 |
ETC |
Ultra Sonic Ranger | |
8 | SRF05-HY |
ETC |
Ultra-Sonic Ranger | |
9 | SRF0703 |
Bourns |
Dual-Winding Shielded Power Inductors | |
10 | SRF08 |
ETC |
UltraSonic Ranger | |
11 | SRF08 |
ETC |
Ultraschall-Modul | |
12 | SRF08 |
ETC |
Ultra sonic range finder |