Pin Symbol Description 1 Vin Connect the input line voltage directly to this pin to enable the internal startup regulator. A constant current source supplies current from this pin to the capacitor connected to the VAUX pin, eliminating the need for a startup resistor. The charge current is typically 10 mA. Maximum input voltage is 100 V. 2 UVOV Input su.
of the NCP1562 are soft- stop and a cycle skip current limit with a time threshold. Soft- stop circuitry powers down the converter in a controlled manner if a severe fault is detected. The cycle skip detector enables a soft- stop sequence if a continuous overcurrent condition is present. Additional features found in the NCP1562 include line feedforward, frequency synchronization up to 1.0 MHz, cycle- by- cycle current limit with leading edge blanking (LEB), independent under and overvoltage detectors, adjustable output overlap delay, programmable maximum duty cycle, internal startup circuit an.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NCP1562B |
ON Semiconductor |
High Performance Active Clamp/Reset PWM Controller | |
2 | NCP1560 |
ON |
Full Featured Voltage Mode PWM Controller | |
3 | NCP1565 |
ON Semiconductor |
Highly Integrated Dual-Mode Active Clamp PWM Controller | |
4 | NCP1566 |
ON Semiconductor |
Dual-Mode Active Clamp PWM Controller | |
5 | NCP1568 |
ON Semiconductor |
AC-DC Active Clamp Flyback PWM | |
6 | NCP1568D |
ON Semiconductor |
DC-DC Active Clamp Flyback PWM | |
7 | NCP1500 |
ON |
Dual Mode PWM/Linear BUCK Converter | |
8 | NCP1501 |
ON Semiconductor |
Dual Mode PWM/Linear Buck Converter | |
9 | NCP1508 |
ON Semiconductor |
High Efficiency Synchronous Step-Down DC-DC Converter | |
10 | NCP1509 |
ON Semiconductor |
High Efficiency Synchronous Step-Down DC-DC Converter | |
11 | NCP151 |
ON Semiconductor |
LDO Regulator | |
12 | NCP1512 |
ON Semiconductor |
PWM Buck Converter |