This pin directly connects to an optocoupler collector. This pin monitors the input voltage image to offer a Brown−out protection. Monitors the primary current and allows the selection of the ramp compensation amplitude. A resistor connected to ground fixes the switching frequency. The controller ground pin. This pin connects to the MOSFET gate This pin acce.
Peak Current Mode Control
Adjustable Switching Frequency up to 500 kHz
Jittering Frequency 5% of the Switching Frequency
Latched Primary Over Current Protection with 10 ms Fixed Delay
Delay Extended to 150 ms in E Version
Delayed Operation Upon Start−up via an Internal Fixed Timer
(A, B and C versions only)
Adjustable Soft−start Timer
Auto−recovery Brown−Out Detection
UC384X−like UVLO Thresholds
Vcc Range from 9 V to 28 V with Auto−recovery UVLO
Internal 160 ns Leading Edge Blanking
Adjustable Internal Ramp Compensation
+500 mA /
–800 mA Source / Sink Capability
Ma.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NCP1250 |
ON Semiconductor |
Current-Mode PWM Controller | |
2 | NCP1251 |
ON Semiconductor |
Current-Mode PWM Controller | |
3 | NCP12510 |
ON Semiconductor |
Current-Mode PWM Controller | |
4 | NCP1253 |
ON Semiconductor |
Current-Mode PWM Controller | |
5 | NCP1254 |
ON Semiconductor |
Current-Mode PWM Controller | |
6 | NCP1255 |
ON Semiconductor |
Current-Mode PWM Controller | |
7 | NCP1256 |
ON Semiconductor |
Low Power Offline PWM Controller | |
8 | NCP120 |
ON Semiconductor |
Very Low Dropout Bias Rail CMOS Voltage Regulator | |
9 | NCP1200 |
ON Semiconductor |
PWM Current-Mode Controller | |
10 | NCP1200A |
ON Semiconductor |
PWM Current-Mode Controller | |
11 | NCP1200CH |
ON Semiconductor |
PWM Controller | |
12 | NCP1200D |
ON Semiconductor |
PWM Controller |