section. ELECTRICAL CHARACTERISTICS (VDD = VCC = 2.7 to 5.5 V, Voltages Referenced to GND, unless otherwise stated; VPD = 2.7 to 5.5 V, TA = – 40 to 85°C) Symbol VIL VIH VHys VOL VOH IOL IOL IOL IOL IOH IOH IOH Parameter Maximum Low–Level Input Voltage (Din, CLK, ENB) Minimum High–Level Input Voltage (Din, CLK, ENB) Minimum Hysteresis Voltage (CLK, ENB) Ma.
a single
–ended current source/sink phase detector A output and a double
–ended phase detector B output. Both phase detectors have linear transfer functions (no dead zones). The maximum current of the single
–ended phase detector output is determined by an external resistor tied from the Rx pin to ground. This current can be varied via the serial port. Slew
–rate control is provided by a special driver designed for the REFout pin. This minimizes interference caused by REFout. This part includes a differential RF input that may be operated in a single
–ended mode. Also featured are on
–board support .
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | MC145200 |
Motorola |
2.0 GHz PLL Frequency Synthesizers | |
2 | MC145201 |
Motorola |
2.0 GHz PLL Frequency Synthesizers | |
3 | MC14520B |
Motorola |
DUAL UP COUNTERS | |
4 | MC14520B |
ON Semiconductor |
Dual Up Counters | |
5 | MC14521B |
ON Semiconductor |
24-Stage Frequency Divider | |
6 | MC14521B |
Motorola |
24-Stage Frequency Divider | |
7 | MC145220 |
Motorola |
Dual 1.1 GHz PLL Frequency Synthesizer | |
8 | MC14522B |
Motorola |
Presettable 4-Bit Down Counters | |
9 | MC14526B |
ON Semiconductor |
Presettable 4-Bit Down Counters | |
10 | MC14527B |
Motorola |
BCD Rate Multiplier | |
11 | MC14528B |
ON Semiconductor |
Dual Monostable Multivibrator | |
12 | MC14529B |
Motorola |
Dual 4-Channel Analog Data Selector |