| No. | Partie # | Fabricant | Description | Fiche Technique |
|---|---|---|---|---|
|
|
|
TAITRON |
Positive Voltage Regulator • Input Voltage up to 20V • Output Current up to 1A • Low Drop Output Voltage:Typical 1.15V at 1A output current • Output Voltage Accuracy : ±1% for fixed output Voltage 1.5V,1.8V, 2.5V ,2.85V, 3.3V,5.0V and Adjustble Output Voltage Version. ±2% for |
|
|
|
|
ST Microelectronics |
Low drop fixed and adjustable positive voltage regulators • Low dropout voltage: – 1.15 V typ. @ IOUT = 1 A, 25 °C • Very low quiescent current: – 5 mA typ. @ 25 °C • Output current up to 1 A The LD1117A is a low drop voltage regulator able to provide up to 1 A of output current, available also in adjustab |
|
|
|
|
Seme LAB |
0.5 AMP POSITIVE ADJUSTABLE VOLTAGE REGULATOR 4 5 ° 1 2 .7 0 (0 .5 0 0 ) m in . • Ouput Voltage Range Adjustable: 1.25 to 40V For Standard Version 1.25 to 60V For –HV Version • 1% Output Voltage Tolerance ( –A Versions) H Package TO39 Pin 1 = Vin Pin 2 = ADJ. Pin 3 =Vout • 0.3% Load Regulatio |
|
|
|
|
AP Semiconductor |
Positive Low Dropout Linear Regulator ■ Adjustable or fixed output(1.2V, 1.5V, 1.8V, 2.5V, 3.3V, 5V) ■ Output Current of 1A ■ Safe Operating Area (SOA) Protection ■ Over Voltage Protection (OVP) ■ Over Current Protection (OCP) ■ Thermal shutdown protection ■ Low dropout, 1.1V Typical at |
|
|
|
|
TAITRON |
1A Low Dropout Positive Voltage Regulator • • • • • • Input Voltage up to 20V Output Current up to 1A Low Drop Output Voltage:Typical 1.15V at 1A output current Trimmed Current Limit and On-Chip Thermal Shutdown Operation Junction Temperature: -40°C to 125°C RoHS Compliance and Halogen Free |
|
|
|
|
SiTI |
3-Channel Secondary Monitoring IC z z z z z z z z z z z z Over voltage protection and lock out Short circuit protection and lock out Fault protection output with open drain output stage Open drain power good output signal for power good input Built-in 300ms power good delay 75ms dela |
|
|
|
|
AiT Semiconductor |
1A LOW-DROPOUT POSITIVE VOLTAGE REGULATOR Output Current of 1A Maximum Three-Terminal Adjustable or Fixed Outputs The A1117 series of positive fixed voltage (VOUT = 1.8V, 2.5V, 2.8V, 3.3V, 5V) and adjustable version, which can provide an output voltage from 1.25V to 13.8V with only two exte |
|
|
|
|
LRC |
LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORS *Low dropout voltage (1V Typ.) *2.85V device performances are suitable for SCSI-2 active termination www.DataSheet4U.com *Output current up to 0.8/1.0A *Fixed output voltage of: 1.5V, 1.8V, 2.5V, 2,85V, 3.0V, 3.3V, *3.6V, 5.0V *Adjustable version ava |
|
|
|
|
Analog Devices |
High Sensitivity Optical Sensor Ultrahigh detectivity photodetector 90 fA/√Hz (typical) ultralow noise floor Signal-to-noise ratio (SNR) near shot noise limit 137 µA (typical) of supply current when active (EE = 0 µW/cm2) 1 µA (typical) of supply current in standby High speed, deep |
|
|
|
|
UTC |
LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORS * Low dropout voltage * Suitable for SCSI-2 active termination if VOUT set to 2.85V * Output current up to 0.8A for 1117 and 1.0A for 1117A * Built-in current limit and over temperature protection * Low current consumption * Support MLCC 1 TO-263 1 |
|
|
|
|
natlinear |
High Sensitivity CMOS Hall IC Micro power design 2.4 V to 5.5 V battery operation High sensitivity and high stability of the magnetic switching points High resistance to mechanical stress Digital output signal interactive model of the magnetic field induction ■ Pack |
|
|
|
|
Microsemi Corporation |
0.8/ 1 & 1.2A LOW DROPOUT POSITIVE REGULATORS m power source when they are operated under short-circuit conditions. The regulator's internal circuitry will operate at input-to-output differential voltages down to 1V. Most regulator circuit designs include output capacitors with values in the ran |
|
|
|
|
ON Semiconductor |
1.0 A Low-Dropout Positive Fixed and Adjustable Voltage Regulators |
|
|
|
|
Analog Technology |
1A Low Dropout Positive Adjustable or Fixed-Mode Regulator • 1.4V maximum dropout at full load current • Fast transient response • Output current limiting • Built-in thermal shutdown • Packages: SOT223, TO252, TO220, SOT89 • Good noise rejection • 3-Terminal Adjustable or Fixed 1.5V, 1.8V,2.5V, 3.3V, 5.0V |
|
|
|
|
Vishay Siliconix |
800mA Low Dropout Positive Adjustable Regulator • Dropout Voltage 1.2V at 800mA Output Current • Fast Transient Response • Line Regulation typically at 0.015% • Load Regulation typically at 0.1% • Internal thermal limiting • Adjustable Output Voltage or Fixed 2.5V, 2.85V, 3.3V, 5V • Standard 3-Pin |
|
|
|
|
Allegro |
Sensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches and Benefits ▪ Chopper stabilization ▫ Low switchpoint drift over operating temperature range ▫ Low sensitivity to stress ▪ Factory programmed at end-of-line for optimized switchpoints ▪ On-chip protection ▫ Supply transient protection ▫ Reverse-batt |
|
|
|
|
ST Microelectronics |
Adjustable and fixed low drop positive voltage regulator • Low dropout voltage (1 V typ.) • 2.85 V device performances are suitable for SCSI-2 active termination • Output current up to 800 mA • Fixed output voltage of: 1.2 V, 1.8 V, 2.5 V, 3.3 V, 5.0 V • Adjustable version availability (VREF = 1.25 V) • In |
|
|
|
|
UTC |
LOW DROP POSITIVE VOLTAGE REGULATORS * 2.85V device are suitable for SCSI-2 active termination * Output current up to 1A * Adjustable version available.(VREF=1.24V) * Internal current and thermal limit * Available in ±1%(at 25°C) and 2% in all temperature range 1 1 TO-263 1 TO-263-3 |
|
|
|
|
Anpec Electronics |
1A Low Dropout Fast Response Positive Adjustable Regulator • • • • • • • • • • Guaranteed Output Voltage Accuracy within 2% Fast Transient Response Guaranteed Dropout Voltage at Multiple Currents Load Regulation : 0.1% Typ. Line Regulation : 0.03% Typ. Low Dropout Voltage : 1.1V Typ. at IOUT =1A Current Limi |
|
|
|
|
Seme LAB |
POSITIVE ADJUSTABLE VOLTAGE REGULATOR • HERMETIC TO220 METAL OR CERAMIC SURFACE MOUNT PACKAGES 1 23 1 3 .7 0 • SCREENING OPTIONS AVAILABLE 1.0 2 .5 4 BSC 0 .8 9 (0 .0 3 5 ) m in . • ALL LEADS ISOLATED FROM CASE(METAL PACKAGE) • OUTPUT VOLTAGE RANGE OF 1.25 TO 37V (1.25 TO 57V FOR -HV |
|