| No. | Partie # | Fabricant | Description | Fiche Technique |
|---|---|---|---|---|
|
|
|
Pericom Semiconductor |
2-Bit Bus Switch Description Near-Zero propagation delay 5-ohm switches connect inputs to outputs High signal passing bandwidth (500 MHz) Beyond Rail-to-Rail switching - 0 to 5V switching with 3.3V power supply - 0 to 3.3V switching with 2.5V power supply |
|
|
|
|
Fairchild Semiconductor |
Dual 4:1 Multiplexer/Demultiplexer Bus Switch with 25 Series Resistor in Outputs s 25Ω switch connection between two ports s Minimal propagation delay through the switch s Low lCC s Zero bounce in flow-through mode s Control inputs compatible with TTL level Ordering Code: Order Number FST32253M FST32253QSC FST32253MTC Package Nu |
|
|
|
|
Fairchild Semiconductor |
20-Bit Bus Switch s 4Ω switch connection between two ports. s Minimal propagation delay through the switch. s Low lCC. s Zero bounce in flow-through mode. s Control inputs compatible with TTL level. Ordering Code: Order Number FST16210MTD Package Number MTD48 Package |
|
|
|
|
Hitachi Semiconductor |
Octal Bus Transceivers With 3 State Outputs low power dissipation that is about 1/5 of high speed bipolar logic IC. When the frequency is 10 MHz. The device has eight bus transceivers with three state outputs in a 20 pin package. Each device has an active low enable input ( G ) and a direction |
|
|
|
|
Hitachi Semiconductor |
Octal Bus Transceivers(with three-state outputs) any third party’s patent, copyright, trademark, or other intellectual property rights for information contained in this document. Hitachi bears no responsibility for problems that may arise with third party’s rights, including intellectual property |
|
|
|
|
ON Semiconductor |
Octal 3-State Noninverting Bus Transceiver http://onsemi.com MARKING DIAGRAMS 20 20 1 TSSOP−20 DT SUFFIX CASE 948E 1 HC 245 ALYW G G • • • • • • • • • Output Drive Capability: 15 LSTTL Loads Outputs Directly Interface to CMOS, NMOS, and TTL Operating Voltage Range: 2.0 to 6.0 V Low Input Cu |
|
|
|
|
Fairchild Semiconductor |
Synchronous 16-Bit to 32-Bit Multiplexer/Demultiplexer Bus Switch s 4Ω switch connection between two ports. s Minimal propagation delay through the switch. s Low lCC. s Zero bounce in flow-through mode. s Control inputs compatible with TTL level. Ordering Code: Order Number FST16232MEA FST16232MTD Package Number M |
|
|
|
|
Pericom Semiconductor |
4-bit I2C-bus and SMBus low power I/O port Operation power supply voltage from 2.3V to 5.5V 4-bit I2C-bus GPIO with interrupt and reset 5V tolerant I/Os Active Low interrupt output Active Low reset input Polarity inversion register Low current consumption 0Hz to 1MHz clock fre |
|
|
|
|
Pericom Semiconductor Corporation |
SOTINY Low Voltage SPST Analog Switch/Bus Switch • Low Voltage, SPST Switch – VCC from 2.3V to 3.6V • Low On-Resistance: 6 ohms at 3.0V • CMOS Technology for Bus and Analog Applications • Rail-to-Rail Signal Range • Low Power: 30µW at 3.0V • High Speed: 4ns • High Off Isolation: 65dB at 1MHz • High |
|
|
|
|
Fairchild Semiconductor |
40/48-Bit Bus Switch I 4Ω switch connection between two ports I Minimal propagation delay through the switch I Low lCC I Zero bounce in flow-through mode I Control inputs compatible with TTL level I Packaged in plastic Fine Pitch Ball Grid Array (FBGA) Ordering Code: Or |
|
|
|
|
NXP Semiconductors |
2-wire serial bus extender of the I2C-bus system during the level shifts, it also permits extension of the I2C-bus by providing bidirectional buffering for both the data (SDA) and the clock (SCL) line as well as the rise time accelerator on port A enabling the bus to drive a l |
|
|
|
|
Hitachi Semiconductor |
18-bit Universal Bus Driver with 3-state Outputs and Inverted Latch Enable • Meets “PC SDRAM registered DIMM design support document, Rev. 1.2” • VCC = 2.3 V to 3.6 V • Typical VOL ground bounce < 0.8 V (@VCC = 3.3 V, Ta = 25°C) • Typical VOH undershoot > 2.0 V (@VCC = 3.3 V, Ta = 25°C) • High output current ±12 mA (@V CC = |
|
|
|
|
Hitachi Semiconductor |
Quad. Tridirectional Bus Transceiver • • • • • High Speed Operation High Output Current: Fanout of 15 LSTTL Loads Wide Operating Voltage: VCC = 2 to 6 V Low Input Current: 1 µA max Low Quiescent Supply Current: ICC (static) = 4 µA max (Ta = 25°C) HD74HC442/HD74HC443HD74HC444 Function T |
|
|
|
|
Hitachi Semiconductor |
Octal Bus Transceivers/Registers • • • • • High Speed Operation: tpd (Bus to Bus) = 16 ns typ (CL = 50 pF) High Output Current: Fanout of 15 LSTTL Loads Wide Operating Voltage: VCC = 2 to 6 V Low Input Current: 1 µA max Low Quiescent Supply Current: ICC (static) = 4 µA max (Ta = 25° |
|
|
|
|
Hitachi Semiconductor |
16-bit Bus Transceivers with 3-state Outputs • • • • • • VCC = 2.0 V to 5.5 V All inputs VIH (Max.) = 5.5 V (@VCC = 0 V to 5.5 V) All outputs VOUT (Max.) = 5.5 V (@VCC = 0 V or output off state) Typical VOL ground bounce < 0.8 V (@VCC = 3.3 V, Ta = 25°C) Typical VOH undershoot > 2.0 V (@VCC = 3 |
|
|
|
|
Fairchild Semiconductor |
8-Bit LVTTL/GTLP Bus Transceiver s Bidirectional interface between GTL/GTLP and LVTTL logic levels s Output Edge Rate Control to minimize noise on the GTLP port s Power up/down/off high impedance for live insertion s Standard 245 function s CMOS technology for low power dissipation |
|
|
|
|
ON Semiconductor |
SPI bus flash memory inherent to a serial flash memory device, the LE25U40CMC is housed in an 8-pin ultra-miniature package. All these features make this device ideally suited to storing program in applications such as portable information devices, which are required to |
|
|
|
|
Siemens Semiconductor Group |
16 Kbit 2048 x 8 bit Serial CMOS EEPROMs/ I2C Synchronous 2-Wire Bus/ Page Protection Mode • Data EEPROM internally organized as 2048 bytes and 128 pages × 16 bytes • Page protection mode, flexible page-by-page hardware write protection – Additional protection EEPROM of 128 bits, 1 bit per data page P-DIP-8-4 – Protection setting for each |
|
|
|
|
Motorola Semiconductor |
OCTAL BUS TRANSCEIVER |
|
|
|
|
Fairchild Semiconductor |
General Purpose Interface Bus Circuit |
|