No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
|
|
NXP Semiconductors |
LPC18xx ARM Cortex-M3 microcontroller . • Added the line to the remark in Section 10.4.10 “USB0 frame length adjust register” and Section 10.4.11 “USB1 frame length adjust register”: This register should be read before the initialization of USB0 and USB1. • Fixed typographical error in S |
|
|
|
NXP Semiconductors |
LPC408x/407x User manual Refer to Section 1.4 for details of features for specific part numbers. • Functional replacement for LPC23xx and 24xx family devices. • ARM Cortex-M4 processor, running at frequencies of up to 120 MHz. The Cortex-M4 executes the Thumb®-2 instruction |
|
|
|
NXP Semiconductors |
I2C-bus specification and user manual In consumer electronics, telecommunications and industrial electronics, there are often many similarities between seemingly unrelated designs. For example, nearly every system includes: • Some intelligent control, usually a single-chip microcontroll |
|
|
|
NXP Semiconductors |
I2C Demonstration Board 2005-1 Quick Start Guide ctronics N.V. 2006. All rights reserved. User manual Rev. 01 — 13 June 2006 2 of 12 datasheet pdf - http://www.DataSheet4U.net/ Philips Semiconductors UM10206 I2C Demonstration Board 2005-1 Quick Start Guide 1. Introduction The I2C Demonstrati |
|
|
|
NXP Semiconductors |
LPC17xx User manual and a higher level of support block integration. High speed versions (LPC1769 and LPC1759) operate at up to a 120 MHz CPU frequency. Other versions operate at up to an 100 MHz CPU frequency. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and u |
|
|
|
NXP Semiconductors |
SSL1523 high power factor 5W LED driver river 1. Introduction WARNING Lethal voltage and fire ignition hazard The non-insulated high voltages that are present when operating this product, constitute a risk of electric shock, personal injury, death and/or ignition of fire. This product is |
|
|
|
NXP Semiconductors |
LPC800 User manual • System: – ARM Cortex-M0+ processor, running at frequencies of up to 30 MHz. – ARM Cortex-M0+ built-in Nested Vectored Interrupt Controller (NVIC). – Micro Trace Buffer – System tick timer • Memory: – 4 kB SRAM. http://www.DataSheet4U.net/ – 16 k |
|
|
|
NXP Semiconductors |
User manual for I2C-bus RTC demoboard OM11059A sets are available. The OM11059A is the ideal evaluation/demo board to use in the design phase of any project, just power and I2C-bus must be hooked up. A separate demoboard and a user manual are available for the SPI-bus RTC PCF85063BTL: OM11059 and |
|
|
|
NXP Semiconductors |
SSL2109 reference board enable a driver to operate in Boundary Conduction Mode (BCM) with valley switching where the average current in the inductor is the output current. The SSL2109 turns off the MOSFET when the voltage on pin SOURCE reaches 500 mV. If the value of R4 in |
|