No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
|
|
MPS |
H-Bridge Motor Driver include overcurrent protection (OCP), VIN over-voltage protection (OVP), VCC under-voltage lockout (UVLO), and thermal shutdown. The MP6619L is available in a QFN-19 (3mmx3mm) package. MP6619L 2.5V to 28V, 5A H-Bridge Motor Driver FEATURES • Wide 2. |
|
|
|
MPS |
H-Bridge DC Motor Driver include thermal shutdown, under-voltage lockout (UVLO), and over-current protection (OCP). The MP6615 is available in a TQFN-26 (6mmx6mm) package. FEATURES • 4.75V to 40V Operating Input Voltage (VIN) Range • Internal Full H-Bridge Driver • 8A of Co |
|
|
|
MPS |
DC Motor Driver do not require a low-ohmic shunt resistor. Internal protection features include over-current protection (OCP), short-circuit protection (SCP), under-voltage lockout (UVLO), and overtemperature protection (OTP). The MP6614 requires a minimal number of |
|
|
|
MPS |
Three-Phase BLDC Motor Driver a built-in, configurable speed curve function. It also features a sinusoidal drive for maximum torque, as well as low speed ripple and noise across the full speed range. The MP6631 provides rotational speed detection. The rotational speed detector (t |
|
|
|
MPS |
Simple Three-Phase Power Stage include over-current protection (OCP), input overvoltage protection (OVP), input under-voltage lockout (UVLO), and thermal shutdown. The MP6545A has separate high-side (HS) and low-side (LS) input pins for each output pin. The MP6545A is available in |
|
|
|
MPS |
3-Phase Fan Driver an embedded single Hall sensor for robust start-up performance and 180° full-wave sine-wave control, which provides high efficiency, a low speed ripple, and low vibration across the full speed range. The MP6630 also has a rotational speed detector. T |
|
|
|
MPS |
Simple Dual H-Bridge Driver include over-current protection (OCP), input overvoltage protection (OVP), input under-voltage lockout (UVLO), and thermal shutdown. The MP6604B has PHASE, ENBL, BRAKE, and BMOD input signals for each H-bridge. The MP6604B is available in QFN-28 (4mm |
|
|
|
MPS |
Simple H-Bridge Driver include over-current protection (OCP), input overvoltage protection (OVP), input under-voltage protection (UVP), and thermal shutdown. The MP6613 has several control modes that are configurable via pins. The MP6613 is available in QFN-28 (4mmx5mm) an |
|
|
|
MPS |
Load-Switch Controller VIN Range from 2.2V to 12V P-MOSFET Gate Driver Auto 150Ω Output Discharge <2µA Quiescent Current <1µA Shipping Mode Current Factory-Fixed Reset Delay ESD HBM 2kV Available in a Space-Saving UTQFN-10 (1.4mmx1.8mm) Package APPLICATIONS |
|
|
|
MPS |
H-Bridge Current Regulator include load open, loadshort protection, over-current protection (OCP), over-temperature protection (OTP), and input over-voltage protection (OVP). The MP6519 is available in a QFN-19 (3mmx3mm) package. MP6519 2.5V - 28V, 5A, H-Bridge Current Regula |
|
|
|
MPS |
Simple Three-Phase Power Stage include over-current protection (OCP), input overvoltage protection (OVP), input under-voltage lockout (UVLO), and thermal shutdown. The MP6545 has separate high-side (HS) and low-side (LS) input pins for each output pin. The MP6545 is available in Q |
|
|
|
MPS |
Dual H-Bridge Motor Driver include over-current protection (OCP), input overvoltage protection (OVP), and input undervoltage lockout (UVLO) protection, and thermal shutdown. The MP6604A has separate IN and EN pins for each output pin. The MP6604A is available in QFN-28 (4mmx5m |
|
|
|
MPS |
H-Bridge Motor Driver include over-current protection (OCP), input over-voltage protection (OVP), under-voltage lockout (UVLO), and thermal shutdown. The MP6619 is available in a QFN-19 (3mmx3mm) package. FEATURES Wide 5.4V to 28V Operating Input Range Up to 5A Peak |
|
|
|
MPS |
Phase/Enable Control H-Bridge Motor Driver do not require the use of a low-ohm shunt resistor. Internal safety features include over-current protection, input over-voltage protection, undervoltage lockout (UVLO), and thermal shutdown. The MP6515 is available in 16-pin 5.0mmx6.4mm TSSOP-EP and |
|
|
|
MPS |
High-Efficiency Flyback/Forward Controller Primary-Side Regulated Flyback without Optocoupler Feedback Synchronous Gate Driver (SYNC) Provides High Efficiency for Active-Clamped Forward Topology Wide 8V to 80V Input Voltage Range Internal Circuit Supply Compatible with 16V External Po |
|
|
|
MPS |
1.5A Stepper Motor Driver include overcurrent protection (OCP), input over-voltage protection (OVP), under-voltage lockout (UVLO), and thermal shutdown. The MP6600L is available in a QFN-24 (4mmx4mm) package. MP6600L 35V, 1.5A Stepper Motor Driver with Internal Current Sense |
|
|
|
MPS |
Load-Switch Controller VIN Range from 2.2V to 12V P-MOSFET Gate Driver Auto 150Ω Output Discharge <2µA Quiescent Current <1µA Shipping Mode Current Factory-Fixed Reset Delay ESD HBM 2kV Available in a Space-Saving UTQFN-10 (1.4mmx1.8mm) Package APPLICATIONS |
|
|
|
MPS |
4-Channel Low-Side Driver include over-current protection (OCP), under-voltage lockout (UVLO), and over-temperature protection (OTP). The MP6605C is available in a QFN-24 (4mmx4mm) package. MP6605C 4-Channel, Low-Side Driver with I2C Interface FEATURES • Wide 4.5V to 60V Inp |
|
|
|
MPS |
Dual LLC Synchronous Rectifier • Works with Standard and Logic Level MOSFETs • Compatible with Energy Star • Fast Turn-Off Total Delay of 35ns • Wide 4.2V ~ 35V VDD Operating Range • 175µA Low Quiescent Current in Light-Load Mode • Supports CCM, CrCM, and DCM Operation • Supports |
|
|
|
MPS |
3-Phase Fan Driver a single, embedded Hall-effect sensor for robust start-up performance. It also features 180° full-wave sinusoidal drive for high efficiency, and lowspeed ripple and vibration over the full speed range. The MP6630H also has a rotational speed detector |
|