No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
|
|
Intersil |
3+1 Voltage Regulator Both outputs support DCR current sensing with single NTC thermistor for DCR temperature compensation or accurate resistor current sensing. Both outputs come with remote voltage sense, programmable VBOOT voltage, programmable IMAX, TMAX, adjustable s |
|
|
|
Intersil Corporation |
ISL8502A a bi-directional Enable pin that allows the part to pull the enable pin low during fault detection. PGOOD delay for ISL8502A has been decreased to 1ms typical (at 500kHz switching frequency) compared to 250ms (at 500kHz) for ISL8502. Features • Up t |
|
|
|
Intersil Corporation |
Dual 2+1 PWM Controller Both outputs support either DCR current sensing with a single NTC thermistor for DCR temperature compensation, or more precise resistor current sensing if desired. Both outputs come with remote voltage sense, programmable VBOOT voltage, IMAX, and sw |
|
|
|
Intersil |
5 Channel DC/DC Converter The ISL98602 represents a high-power, integrated LCD supply IC targeted at large panel LCD displays. The ISL98602 integrates a high-power boost converter for AVDD generation, VON and VOFF charge pump drivers, one synchronous buck regulator, and one |
|
|
|
Intersil Corporation |
Transmitters/Receivers an improved charge pump which delivers ±5V transmitter supplies, allowing the use of the ISL8563E in RS-562 and RS-232 applications. RS-562 applications will benefit from the improved noise immunity afforded by the ±5V output swing capability. Table 1 |
|
|
|
Intersil Corporation |
Li-ion/Li-Polymer Battery Charger Accepting Two Power Sources 28V and 7V maximum voltages for the cradle and the USB inputs respectively. Due to the 28V rating for the cradle input, low-cost, large output tolerance adapters can be used safely. When both inputs are powered, the cradle input is used to charge the |
|
|
|
Intersil Corporation |
Op Amps an enable pin that can be used to turn the device off and reduce the supply current to a maximum of 16µA. Operation is guaranteed over -40°C to +125°C temperature range. Features • 4.5MHz gain bandwidth product • 900µA supply current (per amplifier) |
|
|
|
Intersil |
Low Power UniSLIC14 The UniSLIC14 is a family of Ultra Low Power SLICs. The feature set and common pinouts of the UniSLIC14 family positions it as a universal solution for: Plain Old Telephone Service (POTS), PBX, Central Office, Loop Carrier, Fiber in the Loop, ISDN-T |
|
|
|
Intersil |
Low Power UniSLIC14 The UniSLIC14 is a family of Ultra Low Power SLICs. The feature set and common pinouts of the UniSLIC14 family positions it as a universal solution for: Plain Old Telephone Service (POTS), PBX, Central Office, Loop Carrier, Fiber in the Loop, ISDN-T |
|
|
|
Intersil |
Three-Phase Buck PWM Controller that make these controllers compatible include an IMON pin for output current monitoring, and a Power State Indicator (PSI#) pin for phase dropping and higher efficiency during light load states. An 8-bit VID input is used to select the desired outpu |
|
|
|
Intersil |
Single Digitally Controlled Potentiometer |
|
|
|
Intersil Corporation |
SAM Supervisor And Monitor • 12V supply operation • 5V reference output • 5-bit digital-to-analog converter • Programmable DAC Range, within 0.8 –5.0V • Programmable undervoltage and overvoltage thresholds, and latched fault detection • Optional delayed undervoltage (programmab |
|
|
|
Intersil Corporation |
Direct Conversion Transceiver • Highly integrated Dual Band RF to baseband solution • Frequency of operation . . . . . . . . . . . . . . . . 2.4 to 2.5GHz • Low supply operation . . . . . . . . . . . . . . . . . . . . 2.7 to 3.3V • Noise figure . . . . . . . . . . . . . . . . . . |
|
|
|
Intersil Corporation |
Radiation Hardened and SEE Hardened 6A Synchronous Buck Regulator a comparator type enable input that provides flexibility. It can be used for simple digital on/off control or, alternately, can provide undervoltage lockout capability by precisely sensing the level of an external supply voltage using two external re |
|
|
|
Intersil |
Multi-Cell Li-ion Battery Pack OCP/Analog Front-End • Software Selectable Overcurrent Protection Levels and Variable Protect Detection Times - 4 Discharge Overcurrent Thresholds - 4 Short Crcuit Thresholds - 4 Charge Overcurrent Thresholds - 8 Overcurrent Delay Times (Charge) - 8 Overcurrent Delay Tim |
|
|
|
Intersil Corporation |
Dual 4-Phase + 1-Phase PWM Controller remote voltage sensing and completely eliminates any potential difference between remote and local grounds. This improves regulation and protection accuracy. The threshold-sensitive enable input is a vailable to accurately coordinate the start-up of |
|
|
|
Intersil |
Low Power UniSLIC14 The UniSLIC14 is a family of Ultra Low Power SLICs. The feature set and common pinouts of the UniSLIC14 family positions it as a universal solution for: Plain Old Telephone Service (POTS), PBX, Central Office, Loop Carrier, Fiber in the Loop, ISDN-T |
|
|
|
Intersil |
Low Power UniSLIC14 The UniSLIC14 is a family of Ultra Low Power SLICs. The feature set and common pinouts of the UniSLIC14 family positions it as a universal solution for: Plain Old Telephone Service (POTS), PBX, Central Office, Loop Carrier, Fiber in the Loop, ISDN-T |
|
|
|
Intersil |
Three-Phase Buck PWM Controller that make these controllers compatible include an IMON pin for output current monitoring, and a Power State Indicator (PSI#) pin for phase dropping and higher efficiency during light load states. An 8-bit VID input is used to select the desired outpu |
|
|
|
Intersil |
Three-Phase Buck PWM Controller that make these controllers compatible include an IMON pin for output current monitoring, and a Power State Indicator (PSI#) pin for phase dropping and higher efficiency during light load states. An 8-bit VID input is used to select the desired outpu |
|