No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
|
|
Texas Instruments |
BiCMOS Low-Power Current-Mode PWM Controller • Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility • Operating frequency: 1MHz Maximum • 50μA Startup Current, 100μA Maximum • Low operating current: 2.3mA (at fOSC = 52kHz) • Fast, cycle-by-cycle overcurrent limiting: |
|
|
|
ETCTI |
BiCMOS 9-Bit Bus-Interface D-Type Latch With 3-State Outputs |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
BiCMOS Low-Power Current-Mode PWM Controller • Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility • Operating frequency: 1MHz Maximum • 50μA Startup Current, 100μA Maximum • Low operating current: 2.3mA (at fOSC = 52kHz) • Fast, cycle-by-cycle overcurrent limiting: |
|
|
|
Texas Instruments |
BiCMOS POWER-FACTOR PREREGULATOR 1 •2 Controls Boost Preregulator to Near-Unity Power Factor • Limits Line Distortion • World-Wide Line Operation • Overvoltage Protection • Accurate Power Limiting • Average Current Mode Control • Improved Noise Immunity • Improved Feed-Forward Line |
|
|
|
ETC |
CIF Color CMOS Sensor with USB Output • • • • • • • • • • • • • • • • • • CIF format (352x288) pixels, used with 1/7” optical system. QVGA format (320x240) pixels, used with 1/7” optical system QCIF format (176x144) pixels, cropped or subsampled, up to 37.5 fps. Progressive readout Outpu |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
BiCMOS Low-Power Current-Mode PWM Controller • Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility • Operating frequency: 1MHz Maximum • 50μA Startup Current, 100μA Maximum • Low operating current: 2.3mA (at fOSC = 52kHz) • Fast, cycle-by-cycle overcurrent limiting: |
|
|
|
Texas Instruments |
BiCMOS Low-Power Current-Mode PWM Controller • Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility • Operating frequency: 1MHz Maximum • 50μA Startup Current, 100μA Maximum • Low operating current: 2.3mA (at fOSC = 52kHz) • Fast, cycle-by-cycle overcurrent limiting: |
|
|
|
ETC |
ICM102A CIF CMOS image sensor • • • • • • • • • • • • • • • 101,376 (352x288) pixels, CIF format, used with 1/7” optical system Progressive readout Output data format: 8-bit raw data Control interface: SIF Electronic exposure control On-chip 9-bit ADC Correlated double sampling V |
|
|
|
ETC |
Mega pixel Color CMOS image sensor • • • • • • • • • • • • • • • • 1 mega pixels (1152x864) format, used with 1/2” optical system Support sub-sampling at quarter (1/4) mega pixel resolution for higher video frame rate Progressive readout Output data format: 10-bit raw data Input inter |
|
|
|
ETC |
Color CMOS Image Sensor With 574x483 Pixel NTSC Composite Video Output • • • • • • • • • • • • • • • • • • • • 277,242 (574x483) pixels, used with 1/4” optical system Output: NTSC-M, NTSC-J composite video Input interface: SIF Automatic exposure control Electronic exposure control On-chip 9-bit ADC Correlated double sam |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
BiCMOS Low-Power Current-Mode PWM Controller • Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility • Operating frequency: 1MHz Maximum • 50μA Startup Current, 100μA Maximum • Low operating current: 2.3mA (at fOSC = 52kHz) • Fast, cycle-by-cycle overcurrent limiting: |
|
|
|
ETCTI |
BiCMOS Octal Edge-Triggered D-Type Flip-Flop With 3-State Outputs |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
Low-Power BiCMOS Current-Mode PWM Controllers •1 100-μA Typical Starting Supply Current • 500-μA Typical Operating Supply Current • Operation up to 1 MHz • Internal Soft Start • Internal Fault Soft Start • Internal Leading-Edge Blanking of the Current Sense Signal • 1-A Totem-Pole Output • 70-ns |
|
|
|
Texas Instruments |
BiCMOS PFC/PWM Combination Controller D Combines PFC and Downstream Converter Controls D Controls Boost Preregulator to Near-Unity Power Factor D Accurate Power Limiting D Improved Feedforward Line Regulation D Peak Current-Mode Control in Second Stage D Programmable Oscillator D Leading |
|