| No. | Partie # | Fabricant | Description | Fiche Technique |
|---|---|---|---|---|
|
|
|
ETC |
NPN Silicon Transistor Breakdown Voltage at IE=10μA Collector Cutoff Current at VCB=40V Emitter Cutoff Current at VEB=3V Collector Saturation Voltage at IC=100mA, IB=10mA Gain Bandwidth Product at VCE=6V, IC=10mA Output Capacitance at VCB=6V, f=1MHz Noise Figure at VCE=6V, |
|
|
|
|
Texas Instruments |
Quad CMOS Operational Amplifier 1 2(Typical Unless Otherwise Noted) • Rail-to-Rail Input Common-Mode Voltage Range, Ensured Over Temperature • Rail-to-Rail Output Swing within 20 mV of Supply Rail, 100 kΩ Load • Operates from 5V to 15V Supply • Excellent CMRR and PSRR 82 dB • Ultra |
|
|
|
|
Texas Instruments |
Octal Three-State Bus Transceiver Description • Buffered Inputs • Three-State Outputs • Applications in Multiple-Data-Bus Architecture • Fanout (Over Temperature Range) - Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads - Bus Driver Outputs . . . . . . . . . . . . . 15 |
|
|
|
|
Texas Instruments |
Operational Amplifier 1 •2 (Typical Unless Otherwise Noted) • Rail-to-Rail Input Common-Mode Voltage Range (Ensured Over Temperature) • Rail-to-Rail Output Swing (within 20 mV of Supply Rail, 100 KΩ Load) • Ensured 5V and 15V Performance • Operates at 3V. • Excellent CMRR |
|
|
|
|
Texas Instruments |
Fixed-Point Digital Signal Processor − Byte-Addressable (8-/16-/32-/64-Bit Data) − 8-Bit Overflow Protection − Bit-Field Extract, Set, Clear − Normalization, Saturation, Bit-Counting D Host-Port Interface (HPI) − User-Configurable Bus Width (32-/16-Bit) D 32-Bit/33-MHz, 3.3-V PCI Maste |
|
|
|
|
Texas Instruments |
Fixed-Point Digital Signal Processor 12 • High-Performance Fixed-Point DSP (C6454) – 1.39-, 1.17-, and 1-ns Instruction Cycle Time – 720-MHz, 850-MHz, and 1-GHz Clock Rate – Eight 32-Bit Instructions/Cycle – 8000 MIPS/MMACS (16-Bits) – Commercial Temperature [0°C to 90°C] – Extended Tem |
|
|
|
|
ETC |
64K EEPROM : • Extended Power Supply Voltage Single Vcc for Read and Programming (Vcc = 2.7 V to 5.5 V) • Low Power (Isb = 2µa @ 5.5 V) • Extended I²C Bus, 2-Wire Serial Interface • Support Byte Write and Page Write (32 Bytes) • Automatic Page write Operation ( |
|
|
|
|
Texas Instruments |
Quad Micropower CMOS Operational Amplifier 1 •2 (Typical Unless Otherwise Noted) • Ultra Low Supply Current 20 μA/Amplifier • Ensured Characteristics at 3V and 5V • Rail-to-Rail Input Common-Mode Voltage Range • Rail-to-Rail Output Swing – (within 10 mV of rail, VS = 5V and RL = 25 kΩ) • Low |
|
|
|
|
Texas Instruments |
Fixed-Point Digital Signal Processor − Byte-Addressable (8-/16-/32-/64-Bit Data) − 8-Bit Overflow Protection − Bit-Field Extract, Set, Clear − Normalization, Saturation, Bit-Counting − VelociTI.2 Increased Orthogonality D Host-Port Interface (HPI) − User-Configurable Bus Width (32-/16 |
|
|
|
|
ETC |
12 Bit D/A Converter |
|
|
|
|
Texas Instruments |
OCTAL BUS TRANSCEIVERS • Wide operating voltage range of 2V to 6V • High-Current 3-state outputs can drive up to 10 LSTTL loads • Low power consumption, 80-µA max ICC • Typical tpd = 8ns • ±4-mA output drive at 5V • Low input current of 1µA max • Inverting logic 2 Descrip |
|
|
|
|
Texas Instruments |
CMOS Dual Rail-to-Rail Input and Output Operational Amplifier 1 2(Typical unless otherwise noted) • Rail-to-Rail Input Common-Mode Voltage Range (Ensured Over Temperature) • Rail-to-Rail Output Swing (within 20mV of supply rail, 100KΩ load) • Ensured 5V and 15V Performance • Excellent CMRR and PSRR: 82dB • Ultr |
|
|
|
|
Texas Instruments |
Fixed-Point Digital Signal Processor − Byte-Addressable (8-/16-/32-/64-Bit Data) − 8-Bit Overflow Protection − Bit-Field Extract, Set, Clear − Normalization, Saturation, Bit-Counting D Host-Port Interface (HPI) − User-Configurable Bus Width (32-/16-Bit) D 32-Bit/33-MHz, 3.3-V PCI Maste |
|
|
|
|
ETC |
Octal 3-State Inverting Bus Transceiver ata Transmitted from Bus B to Bus A (inverted) Data Transmitted from Bus A to Bus B (inverted) Buses Isolated (High Impedance State) L PIN 20=VCC PIN 10 = GND H H X X = don’t care 496 IN74AC640 MAXIMUM RATINGS* Symbol VCC VIN VOUT IIN IOUT ICC |
|
|
|
|
Texas Instruments |
OCTAL BUS TRANSCEIVERS AND REGISTERS |
|
|
|
|
Texas Instruments |
OCTAL BUS TRANSCEIVERS . The output-enable (OE) input can be used to disable the device so the buses are effectively isolated. ORDERING INFORMATION TA PACKAGE† ORDERABLE PART NUMBER TOP-SIDE MARKING PDIP – N Tube SN74HC645N SN74HC645N –40°C to 85°C SOIC – DW Tub |
|
|
|
|
Texas Instruments |
Digital Signal Processor ............................................................................................................................. 7 1.1 ZTZ/GTZ BGA Package (Bottom View)................................................................................... 8 |
|
|
|
|
Texas Instruments |
Digital Signal Processor − Byte-Addressable (8-/16-/32-/64-Bit Data) − 8-Bit Overflow Protection − Bit-Field Extract, Set, Clear − Normalization, Saturation, Bit-Counting − VelociTI.2 Increased Orthogonality D Host-Port Interface (HPI) − User-Configurable Bus Width (32-/16 |
|
|
|
|
Texas Instruments |
Dual Micropower Rail-to-Rail Output Single Supply Operational Amplifier 1 •2 (Typical, VS = 2.2V) • Output Swing to Within 30 mV of Supply Rail • High Voltage Gain 103 dB • Gain Bandwidth Product 9.5 KHz • Ensured for: 2.2V, 5V, 10V • Low Supply Current 0.95 µA/Amplifier • Input Voltage Range −0.3V to V+ -0.9V • 2.1 µW/A |
|
|
|
|
Texas Instruments |
CMOS Dual Rail-to-Rail Input and Output Operational Amplifier • Rail-to-rail input common-mode voltage range (specified over temperature) • Rail-to-rail output swing (within 20mV of supply rail, 100kΩ load) • Specified 3V, 5V, and 15V performance • Excellent CMRR and PSRR: 82dB • Ultra-low input current: 20fA • |
|