No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
|
|
CHIP |
Octal E1/T1 Line Interface Unit Pin and Software compatible with CP5008/CH5008 Supports 110ohm J1, 100ohm T1, 75ohm E1 coaxial and 120ohm E1 twisted pair applications Programmable Waveform Shaper Line Coding Error Counting and Insertion Crystal-less jitter attenuator Constant throu |
|
|
|
Central Semiconductor |
PNP Amp / Switch Transistor Chip |
|
|
|
Central Semiconductor |
Small Signal Transistor PNP - Amp/Switch Transistor Chip |
|
|
|
CHIP |
Single Channel E1 Transceiver CP5021 Complete E1 transceiver Short haul line interface for clock/data recovery Programmable Waveform Shaper 32-bit or 64-bit crystal-less jitter attenuator Supports framed or unframed data receive and transmit LQFP64 Supports FAS, CAS, CCS and CR |
|
|
|
CHIP |
Octal E1 Transceiver ·Eight channels E1 transceiver ·Onboard line interface for clock/data recovery and waveshaping ·Supports 75ohm E1 coaxial and 120ohm E1 twisted pair applications ·32-bit or 64-bit jitter attenuator ·Loss of signal indication with programmable thresho |
|
|
|
Freescale Semiconductor |
System Basis Chip - SBC and enhances present module designs. The device works as an advanced power management unit for the MCU with additional integrated circuits such as sensors and CAN transceivers. It has a built-in enhanced high-speed CAN interface (ISO11898-2 and -5) w |
|
|
|
CHIP |
Quad E1/T1 Line Interface Unit ·Four channel E1/T1/J1 LIU ·3.3V supplies with 5V tolerant I/O ·Ultra low power consumption, 120mw per channel (typ.) ·Crystal-less jitter attenuator ·Constant throughput delay ·Meets ITU G.736, G.742, G.823 and ETSI CTR12/13 specification ·Optimize |
|
|
|
centralsemi |
PNP - Low Noise Amplifier Transistor Chip |
|
|
|
Freescale Semiconductor |
System Basis Chip - SBC and enhances present module designs. The device works as an advanced power management unit for the MCU with additional integrated circuits such as sensors and CAN transceivers. It has a built-in enhanced high-speed CAN interface (ISO11898-2 and -5) w |
|