The bq2050 Lithium Ion Power Gauge™ IC is intended for batterypack or in-system installation to maintain an accurate record of available battery capacity. The IC monitors a voltage drop across a sense resistor connected in series between the negative battery terminal and ground to determine charge and discharge activity of the battery. Compensations for batt.
➤ Conservative and repeatable measurement of available capacity in Lithium Ion rechargeable batteries ➤ Designed for battery pack integration - 120µA typical operating current - Small size enables imple- mentations in as little as 1 2 square inch of PCB ➤ Integrate within a system or as a stand-alone device - Display capacity via single- wire serial communication port or direct drive of LEDs ➤ Measurements compensated for current and temperature ➤ Self-discharge compensation using internal temperature sensor ➤ 16-pin narrow SOIC General Description The bq2050 Lithium Ion Power Ga.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | bq2050H |
Benchmarq |
Low-Cost Lithium Ion Power Gauge | |
2 | bq2052 |
Benchmarq |
Gas Gauge | |
3 | bq2054 |
UNITRODE |
Lithium Ion Fast-Charge | |
4 | bq2057 |
Texas Instruments |
Linear Charge Management | |
5 | bq2057C |
Texas Instruments |
Linear Charge Management | |
6 | bq2057T |
Texas Instruments |
Linear Charge Management | |
7 | bq2057W |
Texas Instruments |
Linear Charge Management | |
8 | BQ2000 |
Texas Instruments |
Programmable Multi-Chemistry Fast-Charge Management | |
9 | BQ2000T |
Texas Instruments |
Programmable Multi-Chemistry Fast-Charge Management | |
10 | BQ2001-7R |
Power-One |
60...132 Watt DC-DC Converters | |
11 | BQ2002 |
Benchmarq |
NiCd/NiMH Fast-Charge Management | |
12 | BQ2002C |
UNITRODE |
NiCd/NiMH Fast-Charge Management |