NOTE DO NOT MOVE JUMPER W1 UNLESS YOUR OPERATING SYSTEM IS CONFIGURED TO ACCEPT TWO HARD DISK CONTROLLERS. CERTAIN OPERATING SYSTEMS SUPPORT TWO CONTROLLERS IN THE SAME SYSTEM. IBM DOS AND MANY IBMCOMPATIBLE OPERATING SYSTEMS DO NOT SUPPORT THIS FEATURE. Primary/secondary I/O address jumper. Standard factory setting. Jumper in this position selects base prim.
connector to J3 (Drive D or 2). 8. Connect data cables to drives. 9. Attach 34-pin floppy cable connector to J1. Connect cable to floppy drive. This step applies to WD1002-WA2 and WDl003-WA2 users only. 10. Attach Winchester activity LED connector to J6 for all controllers except the WDl002-WAH. The reference designator for the Winchester activity LED connector on the WD1002-WAH is J4. 11. Install the controller board into the expansion slot. Make sure that the board is seated properly by pressing down on both ends of the board. Secure the board with the bracket screw. 12. Remove or disable an.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | WD1002-05 |
Western Digital |
Winchester Floppy Disk Controller | |
2 | WD1002-SHD |
Western Digital |
Winchester Controller OEM Manual | |
3 | WD1003 |
Western Digital |
User Guide | |
4 | WD1003-RA2 |
Western Digital |
Disk Controllers User Guide | |
5 | WD1003-RAH |
Western Digital |
Disk Controllers User Guide | |
6 | WD1003A-RA2 |
Western Digital |
Disk Controllers User Guide | |
7 | WD1003S-RAH |
Western Digital |
Disk Controllers User Guide | |
8 | WD1004-27x |
Western Digital |
Winchester Disk Controller Boards | |
9 | WD1004A-WXI |
Western Digital |
Winchester Disk Controller Boards | |
10 | WD1010 |
Western Digital |
Winchester Disk Controller | |
11 | WD1012EA-5 |
WillSEMI |
600mA Synchronous Step-Down Regulator | |
12 | WD1015 |
WillSEMI |
Step-down DC-DC Converter |