For TC233AX COM Control Output Relay Output NC NO SSR Drive Output 3 + 12 12 VDC R 1 2 5 6 7 Initial calibration is valid for 18 months after the Month/Year of manufacturing which is mentioned on order code label. 13 COM Temp. Proportional band Measured Value Input Thermocouple (J, K, T, R, S) TC+ RTD (Pt100) 8 9 RTD1 Pt100 RTD2 1 8 9 1) Displ.
0 amps it is always necessary to use an interposing relay or contactor that will switch the load. This avoids damage to the controller in the event of a fault short developing on the power output circuit. 3. Always use a separate fused supply for the “power load circuit”and do not take this from the live and neutral terminals supplying power to the controller. For load current less than 0.5A L TC TC C NO MOV Snubber LOAD R C CAUTION 1. When powering up for the first time, disconnect the output connections. 2. Fuse Protection: The unit is normally supplied without a power switch and fuses. Mak.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | TC23-11EWA |
Kingbright |
58mm (2.3 INCH) 8x8 DOT MATRIX DISPLAY | |
2 | TC23-11GWA |
Kingbright |
58.34mm (2.3 INCH) 8x8 DOT MATRIX DISPLAY | |
3 | TC23-11SRWA |
Kingbright |
58mm (2.3 INCH) 8x8 DOT MATRIX DISPLAY | |
4 | TC2300H |
Lite-On Technology |
(TC2300H / TC2600H) SURFACE MOUNT THYRISTOR SURGE PROTECTIVE DEVICE | |
5 | TC2309 |
FUMAN ELECTRONICS |
30V high-density P-channel MOS transistor | |
6 | TC230HT |
Allied Components International |
Toroidal Chokes High Temp | |
7 | TC232 |
TelCom Semiconductor |
DUAL RS-232 TRANSMITTER/RECEIVER | |
8 | TC232 |
Microchip Technology |
DUAL RS-232 TRANSMITTER/RECEIVER AND POWER SUPPLY | |
9 | TC2320 |
Supertex |
N- and P- Channel Enhancement-Mode Dual MOSFET | |
10 | TC236 |
ETCTI |
680-x 500-Pixel CCD Image Sensor (Rev. A) | |
11 | TC20 |
NEC |
Small Induction Transistor | |
12 | TC20-11 |
ETC |
50MM (2.0 INCH) 5 X 7 DOT MATRIX DISPLAYS |