The DPHY440 is a one to four lane and clock MIPI DPHY re-timer that regenerates the DPHY signaling. The device complies with MIPI DPHY 1.1 standard and can be used in either a MIPI CSI-2 or MIPI DSI application at datarates of up to 1.5 Gbps. The device compensates for PCB, connector, and cable related frequency loss and switching related loss to provide the.
•1 MIPI DPHY 1.1 Specification compliant
• Enables low-cost cable solutions
• Supports up to 4 lanes at 1.5 Gbps
– CSI-2/DSI Clock rates from 100 MHz To 750 MHz
• Sub mW Power in shutdown state
• MIPI DSI Bi-directional LP mode supported
• Supports for both ULPS and LP power states
• Adjustable output voltage swing
• Selectable TX Pre-emphasis levels
• Adjustable Rx EQ to compensate for ISI loss
• Configurable edge rate control
• Dynamic data and clock skew compensation
• 3-kV ESD HBM protection
• Industrial temperature range:
–40°C to 85°C
(SN65DPHY440SS)
• Commercial temperature range: 0°C t.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | SN75DP118 |
Texas Instruments |
DisplayPort 1:1 Buffer | |
2 | SN75DP119 |
Texas Instruments |
DisplayPort 1:1 Signal Repeater and Signal Conditioner | |
3 | SN75DP120 |
Texas Instruments |
DisplayPort 1:1 Dual-Mode Repeater | |
4 | SN75DP122A |
Texas Instruments |
DisplayPort 1:2 Switch | |
5 | SN75DP126 |
Texas Instruments |
1:2 Re-Driver Switch | |
6 | SN75DP128A |
Texas Instruments |
DisplayPort 1:2 Switch | |
7 | SN75DP129 |
Texas Instruments |
DisplayPort to TMDS Translator | |
8 | SN75DP130 |
Texas Instruments |
1:1 Redriver | |
9 | SN75DP139 |
Texas Instruments |
DisplayPort to TMDS Level-Shifting Re-Driver | |
10 | SN75DP149 |
Texas Instruments |
3.4 Gbps DP++ to HDMI Retimer | |
11 | SN75DP159 |
Texas Instruments |
6-Gbps AC-Coupled TMDS to HDMI Level Shifter Retimer | |
12 | SN7500 |
KODENSHI |
Pulse Width Modulation |