SM-BF50 - Mini-Circuits

SM-BF50 50OHM DC to 2 GHz

Serial Clock (SCL) The SCL input is used to clock data into the device on the rising edge and to clock data out of the device on the falling edge. Serial Data (SDA) SDA is a bidirectional pin used to transfer addresses, data or control information into the device or to transfer data out of the device. The output is open drain, performing a wired AND function.

Features

• Data EEPROM internally organized as 8192 bytes and 256 pages × 32 bytes
• Page Protection Mode for protecting the EEPROM against unintended data changes (SLx 24C64.../P types only)
• Low power CMOS
• VCC = 2.7 to 5.5 V operation
• Two wire serial interface bus, I2C-Bus compatible
• Three chip select pins to address 8 devices
• Filtered inputs for noise suppression with Schmitt trigger
• Clock frequency up to 400 kHz
• High programming flexibility
  – Internal programming voltage
  – Self timed programming cycle including erase
  – Byte-write and page-write programming, between 1 and 32 bytes
  – Typ.