# 0 ~300 dry soil # 300~700 humid soil # 700~950 in water */ void setup(){ Serial.begin(57600); } void loop(){ Serial.print("Moisture Sensor Value: "); Serial.println(analogRead(A0)); delay(100); } Open the Arduino Serial Monitor, and choose its baud rate 57600 as set in the code. More Share Relative humidity to absolute humidity calculator .
.3v or 5v
Output voltage signal: 0~4.2v
Current: 35mA
Pin definition:
Analog output(Blue wire) GND(Black wire) Power(Red wire)
Size: 60x20x5mm
Value range: 0 ~300 : dry soil 300~700 : humid soil 70050 : in water
Usage
Moisture sensor Connection diagram
/
*
# Example code for the moisture sens or
# Editor
: Lauren
# Date
: 13.01.2012
# Version : 1.0
# Connect the sensor to the A0(Analo g 0) pin on the Arduino board
# the sensor value description
# 0 ~300
dry soil
# 300~700
humid soil
# 700~950
in water
*/
void setup(){
Serial.begin(57600);
}
void loop(){
Serial.pri.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | SEN012 |
Power Integrations |
Zero Loss High Voltage Sense Signal Disconnect IC | |
2 | SEN012DG |
Power Integrations |
Zero Loss High Voltage Sense Signal Disconnect IC | |
3 | SEN013 |
Power Integrations |
Zero Loss High Voltage Sense Signal Disconnect IC | |
4 | SEN013DG |
Power Integrations |
Zero Loss High Voltage Sense Signal Disconnect IC | |
5 | SEN01G64D1BF1SA-25R |
Swissbit |
SDRAM SO-DIMM | |
6 | SEN01G64D1BF1SA-30R |
Swissbit |
SDRAM SO-DIMM | |
7 | SEN0019 |
ETC |
ADJUSTABLE INFRAREDSENSOR SWITCH | |
8 | SEN04G64D2BC2MT-25R |
Swissbit |
SDRAM SO-DIMM | |
9 | SEN04G64D2BC2MT-25W |
Swissbit |
SDRAM SO-DIMM | |
10 | SEN04G64D2BC2MT-30R |
Swissbit |
SDRAM SO-DIMM | |
11 | SEN04G64D2BC2MT-30W |
Swissbit |
SDRAM SO-DIMM | |
12 | SEN04G64D2BC2MT-xxR |
Swissbit |
SDRAM SO-DIMM |