• Thermally protected PCA82C252 • Bus lines protected against transients in an automotive environment • An unpowered node does not disturb the bus lines. Support for low-power modes • Low current sleep/standby mode with wake-up via the bus lines • Power-on reset flag on the output. The PCA82C252 is the interface between the CAN protocol controller and the.
Optimized for in-car low-speed communication
• Baud rate up to 125 kBaud
• Up to 15 nodes can be connected
• Supports unshielded bus wires
• Low RFI due to built-in slope control function
• Fully integrated receiver filters. Bus failure management
• Supports one-wire transmission modes with ground offset voltages up to 1.5 V
• Automatic switching to single-wire mode in the event of bus failure
• Automatic reset to differential mode if bus failure is removed. Protection
• Short-circuit proof to battery and ground in 12 V powered systems QUICK REFERENCE DATA SYMBOL VCC VBAT PARAMETER supply volt.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | PCA82C250 |
NXP |
CAN controller interface | |
2 | PCA82C250T |
NXP |
CAN controller interface | |
3 | PCA82C251 |
NXP |
CAN transceiver for 24 V systems | |
4 | PCA82C251 |
COMSET |
CAN transceiver | |
5 | PCA82C251 |
Philips |
CAN transceiver | |
6 | PCA82C200 |
NXP |
STAND-ALONE CAN-CONTROLLER | |
7 | PCA84C122 |
NXP |
8-bit microcontrollers for remote control transmitters | |
8 | PCA84C222 |
NXP |
8-bit microcontrollers for remote control transmitters | |
9 | PCA84C422 |
NXP |
8-bit microcontrollers for remote control transmitters | |
10 | PCA84C440 |
NXP |
8-bit microcontrollers with OSD and VST | |
11 | PCA84C441 |
NXP |
8-bit microcontrollers with OSD and VST | |
12 | PCA84C443 |
NXP |
8-bit microcontrollers with OSD and VST |