SYMBOL No IPROBE 1 IN1 3 TYPE DESCRIPTION O Current feedback output pin, Put external resistor on this pin to ground. See application information section for resistor selection I Logic input 1. Controls the H-bridge output. Has internal pull downs. IN2 2 I Logic input 2. Controls the H-bridge output. Has internal pull downs. PGND 7 PWR High-curre.
sleep mode with low quiescent current when both IN1 and IN2 inputs are low. The device is integrated with current chopping regulation, depends on the internal reference Vtrip and the voltage of IPROBE pin, which is proportional to the current output of the integrated current mirror of the current flowing through motor and IPROBE output resistor. The current chopping function limits the current during motor start-up or stall condition. The device is also fully protected from faults including VM undervoltage, overcurrent (output short to battery or short to GND) and overtemperature. When fault c.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NSD7312 |
NOVOSENSE |
Brushed DC Motor Driver | |
2 | NSD7310 |
NOVOSENSE |
Brushed DC Motor Driver | |
3 | NSD7310A |
NOVOSENSE |
Brushed DC Motor Driver | |
4 | NSD-1202 |
austriamicrosystems AG |
Dual Piezo Motor Driver IC | |
5 | NSD-2101 |
austriamicrosystems AG |
Piezo Motor Driver ASIC | |
6 | NSD03A10 |
Nihon Inter Electronics |
DIODE | |
7 | NSD03A20 |
Nihon Inter Electronics |
DIODE | |
8 | nsd03a40 |
Nihon Inter Electronics |
Standard Recovery Diode | |
9 | NSD070AL |
ON Semiconductor |
Switching Diode | |
10 | NSD10-12D12 |
FranMar |
DC-DC Converters | |
11 | NSD10-12D15 |
FranMar |
DC-DC Converters | |
12 | NSD10-12D5 |
FranMar |
DC-DC Converters |