(16 Pin SO Wide Exposed Pad Package) Pin # Label Description 1 OUT1 Channel 1 constant current output to LED. Unused pin should be grounded. 2 VP Supply Voltage Input. 3 Ballast Drive Gate drive for external power distribution PFET. Ground if not used. 4 FB Feedback Sense node for VP regulation. Use feedback resistor divider or connect to VP with a.
• Constant Current Outputs for LED String Drive
• LED Drive Current up to 75 mA per Channel
• Open LED String Diagnostic with Open−Drain Output
• Slew Rate Control Eliminates EMI Concerns
• Low Dropout Operation for Pre−Regulator Applications
• External Modulation Capable
• On−chip 1 kHz Tail PWM Dimming
• Single Resistor for Stop Current Set Point
• Single Resistor for Tail Dimming Set Point
• Overvoltage Set Back Power Limitation
• AEC Q100 Qualified
• 16 Lead SOICW Exposed Pad
• This is a Pb−Free Device
Applications
• Rear Combination Lamps (RCL)
• Daytime Running Lights (DRL)
• Fog Lights .
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NCV7681 |
ON Semiconductor |
100mA Linear Current Regulator/Controller | |
2 | NCV7683 |
ON Semiconductor |
Enhanced 100mA Linear Current Regulator/Controller | |
3 | NCV7685 |
ON Semiconductor |
12 Channels 60mA LED Current Driver | |
4 | NCV760040 |
ON Semiconductor |
Quad High-side Driver | |
5 | NCV7601 |
ON Semiconductor |
Quad Driver | |
6 | NCV7608 |
ON Semiconductor |
Octal Configurable Low/High Side Driver | |
7 | NCV7691 |
ON Semiconductor |
Current Controller | |
8 | NCV7692 |
ON Semiconductor |
Current Controller | |
9 | NCV7693 |
ON Semiconductor |
Automotive LED Controller | |
10 | NCV7694 |
ON Semiconductor |
Safety Controller | |
11 | NCV7001 |
ON Semiconductor |
Quad Variable Reluctance Sensor | |
12 | NCV70501 |
ON Semiconductor |
Micro-Stepping Motor Driver |