Pin Symbol Description 1 VCC Input Supply Voltage. Provides power to the charger. This pin should be bypassed with at least a 4.7 mF ceramic capacitor to ground. 2 FAULT An open−drain output indicating fault status. This pin is pulled LOW under any fault conditions. A FAULT condition resets the counter. 3 CFLG An open−drain output indicating charging or .
• Integrated Voltage and Current Regulation
• No External MOSFET, Sense Resistor or Blocking Diode Required
• Charge Current Thermal Foldback
• Integrated Pre−charge Current for Conditioning a Deeply
Discharged Battery
• Integrated End−of−Charge (EOC) Detection
• 1% Voltage Regulation
• 4.2 V Regulated Output Voltage
• Regulation Maintained without a Battery Present
• Programmable Full Charge Current
• Open−Drain Charger Status and Fault Alert Flags
• 2.8 V Output for AC Present Indication and Powering Charging
Subsystems
• Minimum Input Voltage of 2.4 V Allows Use of Current Limited
Adapters
.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | NCP1835 |
ON Semiconductor |
Integrated Li-Ion Charger | |
2 | NCP1800 |
ON |
Single-Cell Lithium Ion Battery Charge Controller | |
3 | NCP1840 |
ON Semiconductor |
8-Channel Programmable LED Driver | |
4 | NCP1850 |
ON Semiconductor |
Fully Integrated Li-Ion Switching Battery Charger | |
5 | NCP1851 |
ON Semiconductor |
Fully Integrated Li-Ion Switching Battery Charger | |
6 | NCP1851A |
ON Semiconductor |
Fully Integrated Li-Ion Switching Battery Charger | |
7 | NCP1852 |
ON Semiconductor |
Fully Integrated Li-Ion Switching Battery Charger | |
8 | NCP1852A |
ON Semiconductor |
Fully Integrated Li-Ion Switching Battery Charger | |
9 | NCP1854 |
ON Semiconductor |
2.5A Fully Integrated Li-Ion Switching Battery Charger | |
10 | NCP1855 |
ON Semiconductor |
Fully Integrated Li-Ion Switching Battery Charger | |
11 | NCP186 |
ON Semiconductor |
Fast Transient Response Low Voltage 1A LDO Regulator | |
12 | NCP187 |
ON Semiconductor |
Low Dropout Voltage Regulator |