The MP3326 is a 16-channel WLED driver that can operate from a wide 4V to 16V input voltage range. The MP3326 applies 16 internal current sources in each LED string terminal. The LED current of each channel is set by an external current-setting resistor. The maximum current of each channel is up to 50mA (VIN ≥ 4.5V). The device integrates an I2C interface wi.
Wide 4V to 16V Input Voltage Range
16 Channels, 50mA/Ch Maximum (VIN ≥
4.5V)
LED Current Configured by External
Resistor
6-Bit Analog Dimming for Each Channel
12-Bit PWM Dimming for Each Channel
Selectable 220Hz, 250Hz, 280Hz, or 330Hz
PWM Dimming Frequency
Refresh Signal Output
I2C Interface
10 Addresses Configurable via External
Resistor
Configurable LED Current Slew Rate
40µs Phase Shift
Fault Indicator
LED Open-Load Protection
LED Short Protection with Configurable
Threshold
Under-Voltage Lockout (UVLO)
Over-Temperature Protection (OTP)
ELV Directive II Co.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | MP3320A |
MPS |
Charge Pump RGB LED Driver | |
2 | MP3320B |
MPS |
Synchronous Boost RGBW LED Driver | |
3 | MP330 |
Caddock |
(MP312 / MP330) Power Film Resistors | |
4 | MP3306 |
MPS |
700kHz Synchronous Step-Up White LED Driver | |
5 | MP3309 |
MPS |
White LED Driver | |
6 | MP3309C |
MPS |
White LED Driver | |
7 | MP3310 |
MPS |
White LED Driver | |
8 | MP3310N |
MPS |
White LED Driver | |
9 | MP3312 |
MPS |
Dual-Channel White LED Driver | |
10 | MP3314 |
MPS |
Boost White LED Driver | |
11 | MP3336A |
MPS |
Flash LED Driver | |
12 | MP3362 |
MPS |
Boost LED Driver |