The MAS8444a comprises eight digital to analog converters (DACs) each controlled by a two-wire I2C bus. The DACs are individually programmed using an 6-bit word to select an output from one of 64 voltage steps. The maximum output voltage of all DACs is set by Vmax. At power-on all outputs are set to their lowest value. The I2C-bus slave receiver has 3 progra.
• Rail to rail output stages
• Octal 6-bit DACs on a single monolithic chip
• Power supply¡ range from +5V to +12V
• -25 C to +85 C temperature range
• 16-pin PDIL and SO package
• pin to pin compatibility with TDA8444
APPLICATION
• Trimmer replacement
• Automatic gain control
• High resolution monitors
BLOCK DIAGRAM
SDA 3 SCL 4 A0 5 A1 6 A2 7
I C Bus Slave Receiver
2
6-BIT DAC
DAC7
6-BIT DAC
DAC6 DAC5
6-BIT DAC 6-BIT DAC 6-BIT DAC 6-BIT DAC
DAC4 DAC3 DAC2 DAC1
Vmax 2
Reference Voltage Generator
6-BIT DAC 6-BIT DAC
DAC0
1 8 VDD GND
1
DA8444A.005 May 31, 1996
PIN CONFIGURAT.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | MAS8444A |
ETC |
OCTAL 6-BIT TRIMMER IC | |
2 | MAS8444AS |
ETC |
OCTAL 6-BIT TRIMMER IC | |
3 | MAS830 |
Mastech |
Multimetr | |
4 | MAS830BH |
Mastech |
Digital Multimeter Instruction Manual | |
5 | MAS830H |
Mastech |
Digital Multimeter Instruction Manual | |
6 | MAS830LH |
Mastech |
Digital Multimeter Instruction Manual | |
7 | MAS8340 |
Micro Analog Systems |
Voltage Controlled Oscillator | |
8 | MAS838H |
Mastech |
Digital Multimeter Instruction Manual | |
9 | MAS1008 |
Tesla |
MAS1008 | |
10 | MAS1016 |
Micro Analog Systems |
am Receiver | |
11 | MAS1016B |
Micro Analog Systems |
am Receiver | |
12 | MAS1017 |
Micro Analog Systems |
am Receiver |