The HV302 and HV312 Hotswap Controllers perform current limiting, circuit breaker protection, over and under voltage detection power management functions during insertion of cards or modules into live backplanes and connectors. They may be used in systems where active control is implemented in the negative lead of supplies ranging from -10V to -90V or +10V t.
-10V to 90V or +10V to +90V Operation Four PWRGD Flags with Programmable Delays Integrated “normally-on” Gate Clamp eliminates components UV/OV Lock Out & Power-On-Reset (POR) for Debouncing Sense resistor programmed Circuit Breaker & Servo Limit Programmable Circuit Breaker Delay Inrush control using either: Servo or Feedback Capacitor Feedback to RAMP pin saves gate protection components 100ms Start Up Timeout Protection for Output Overload Programmable Inrush Current di/dt Control Programmable Auto-Retry (tens of seconds if desired) Auto-Retry or Latched Operation Application solution for i.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | HV310 |
Supertex Inc |
Inrush Current Limiter Controllers | |
2 | HV311 |
Supertex Inc |
Hot Swap Controller | |
3 | HV3137 |
Supertex Inc |
64-Channel Serial To Parallel Converter With Open Drain Outputs | |
4 | HV3 |
Diotec Semiconductor |
High Voltage Si-Rectifiers | |
5 | HV3-2405E-5 |
Harris Corporation |
World-Wide Single Chip Power Supply | |
6 | HV3-2405E-9 |
Harris Corporation |
World-Wide Single Chip Power Supply | |
7 | HV30 |
Supertex |
High Voltage 7-Segment Latch/Decoder/EL-Display Driver | |
8 | HV300 |
Supertex Inc |
Inrush Current Limiter Controllers | |
9 | HV301 |
Supertex Inc |
Hotswap/ Controllers with Circuit Breaker | |
10 | HV302 |
Supertex Inc |
Sequencing Hotswap Controllers | |
11 | HV320 |
Supertex |
Re-Settable Electronic Circuit Breaker | |
12 | HV320WHB-N00 |
BOE |
LCD |