These devices consist of two independent, high gain, internally frequencycompensated operational amplifiers designed operate from a single supply over a wide range of voltages. Operation from split supplies also is possible if the difference between the two supplies is 3V to 40V, and Vcc is at least 1.5V more positive than the input common-mode voltage, The .
• Two internally compensated OP amps
• Internally frequency compensated for unity gain
• Short Circuit Protected Outputs
• Wide power supply range: 3VDC to 40VDC (Single supply)
• Input common-mode voltage range includes ground
• Large output voltage swing: 0VDC to Vcc-1.5VDC
Logic Diagram (each amplifier)
IN + IN -
+
OUTPUT
-
Pin Configurations
Pin 1: Output 1
1 2 3 4 Out
Pin 5 : Non Inverting Input 2 Pin 6 : Inverting Input 2 Pin 7 : Output 2 Pin 8 : Vcc
8 7 Out
Pin 2: Inverting Input 1 Pin 3: Non Inverting Input 1 Pin 4: VEE
+
6 5
+
Schematic Diagram
Vcc
6uA
100uA Q5
6uA Q6 Cc .
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | HLM358S |
Hi-Sincerity |
Low Power Dual Operational Ampilfiers | |
2 | HLM1230 |
HOWARD BATCHEN |
5mW RED LASER MODULE | |
3 | HLM6323-013211 |
HOSIDEN |
MONO STN DISPLAY | |
4 | HLM8619-010200 |
HOSIDEN |
MONO STN DISPLAY | |
5 | HLM8619-010300 |
HOSIDEN |
MONO STN DISPLAY | |
6 | HLM8619-010500 |
HOSIDEN |
MONO STN DISPLAY | |
7 | HLM8620 |
HOSIDEN |
320 X 240 dots STN LCD | |
8 | HLMA-CH00 |
Agilent(Hewlett-Packard) |
T-13/4 (5 mm)/ T-1 (3 mm)/ High Performance AlInGaP LED Lamps | |
9 | HLMA-CL00 |
Agilent(Hewlett-Packard) |
T-13/4 (5 mm)/ T-1 (3 mm)/ High Performance AlInGaP LED Lamps | |
10 | HLMA-CX00 |
Agilent(Hewlett-Packard) |
T-13/4 (5 mm)/ T-1 (3 mm)/ High Performance AlInGaP LED Lamps | |
11 | HLMA-DG00 |
Agilent(Hewlett-Packard) |
T-13/4 (5 mm)/ T-1 (3 mm)/ High Performance AlInGaP LED Lamps | |
12 | HLMA-DH00 |
Agilent(Hewlett-Packard) |
T-13/4 (5 mm)/ T-1 (3 mm)/ High Performance AlInGaP LED Lamps |