The CR range of protectors are based on the proven technology of the T10 thyristor product. Designed for transient voltage protection of telecommunications equipment, it provides higher power handling than a conventional avalanche diode (TVS) and when compared to a GDT offers lower voltage clamping levels and infinite surge life. Packaged in a transfer molde.
effect the protected system. When a transient occurs, the voltage across the CRXXXX will increase until the breakdown voltage (Vbr) is reached. At this point the device will operate in a similar way to a T.V.S. device and is in an avalanche mode. The voltage of the transient will now be limited and will only increase by a few volts as the device diverts more current. As this transient current rises, a level of current through the device is reached (Ibo) which causes the device to switch to a fully conductive state such that the voltage across the device is now only a few volts (Vt). The volta.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | CR0800SA |
Littelfuse |
The CR range of protectors are based on the proven technology of the T10 thyristor product | |
2 | CR0800SC |
Littelfuse |
The CR range of protectors are based on the proven technology of the T10 thyristor product | |
3 | CR0805 |
LIZ |
Chip Resistors | |
4 | CR0805 |
Bourns Electronic Solutions |
Thick Film Chip Resistor | |
5 | CR0805-10W |
Venkel |
Chip Resistors | |
6 | CR0805-8W |
Venkel |
Chip Resistors | |
7 | CR0805-PF |
BOURNS |
Ultra-Low Lead Content Thick Film Resistor | |
8 | CR0805A |
Bourns |
Chip Resistors | |
9 | CR0805A-AS |
Bourns |
Chip Resistors | |
10 | CR08AS |
Mitsubishi Electric Semiconductor |
LOW POWER USE NON-INSULATED TYPE/ GLASS PASSIVATION TYPE | |
11 | CR08AS |
Powerex Power Semiconductors |
Surface Mount/ Phase Control SCR 0.8 Amperes/400-600 Volts | |
12 | CR01005 |
BOURNS |
Thick Film Chip Resistor |