(refer to the Internal Circuit diagram) (1) Preamplifier Stage The preamplifier is comprised of the level-shift transistor Q101, a differential amplifier (Q102 and Q105), and the active load (Q103 and Q106). The input is a PNP transistor that does not require a coupling capacitor. (2) Pre-drive stage Q118 is the pre-drive transistor. Q122 and Q120 form the l.
1) Rated output of 35mW (RL = 32Ω) off a 3V power supply. 2) Low “pop” noise when power is switched on and off. 3) Low quiescent current (13mA). 4) Excellent ripple rejection ratio (38dB). 5) Begins operating at 1.5V. FBlock diagram 6) 7) 8) 9) 10) Low distortion (0.05% at PO = 5mW). Good voltage gain balance between channels. Good channel separation (60dB Typ.). Input coupling capacitors not required. Symmetrical pin assignments facilitates PCB design. 373 Audio ICs FInternal circuit configuration BA5204F FCircuit description (refer to the Internal Circuit diagram) (1) Preamplifier Stag.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | BA520 |
Iskra Semic |
(BA5xx) Diodes | |
2 | BA5206BF |
ROHM |
3V 64mW Dual Power Amplifier | |
3 | BA5208AF |
Rohm |
3V 400MW BTL POWER AMPLIFIER | |
4 | BA521 |
Iskra Semic |
(BA5xx) Diodes | |
5 | BA5210FS |
Rohm |
Speaker / headphone switch power amplifier | |
6 | BA523 |
Iskra Semic |
(BA5xx) Diodes | |
7 | BA524 |
Rohm |
Power Amplifier | |
8 | BA526 |
Rohm |
6V/430mW single-channel power amplifier | |
9 | BA527 |
ROHM Electronics |
6v/800mw Single-channel Power Amplifier | |
10 | BA505 |
XPiQ |
DC / DC Converters | |
11 | BA5096 |
ETC |
BA5096 | |
12 | BA50BC0FP |
Rohm |
1.0A Low-Dropout Voltage Regulator with Shut down Switch |