www.DataSheet4U.com AN597 Implementing Ultrasonic Ranging Author: Robert Schreiber Logic Products Division THEORY OF OPERATION Ultrasonic ranging entails transmitting a sound wave and measuring the time that it takes for the sound wave to reflect off of an object and back to the origin. The reflection time is proportional to the distance that the object is f.
4 is connected to the ranging module as shown in Figure 1. The RE0 and RE1 I/O pins are configured as digital outputs and are tied to INIT and BINH, respectively. The CCP1 pin is configured as a digital input and is tied to ECHO through a pull-up resistor. The pull-up resistor is needed since the ECHO signal is an open-collector output. The CCP1 pin is configured for capture mode (CCP1CON). Figure 2 shows the timing relationship for VDD and the three signal lines (INIT, BINH, and ECHO). Note: The ranging module requires 5.0 milliseconds to stabilize during power-up. This application note describ.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | AN5900 |
Matsushita |
Switching Regulator Controller | |
2 | AN5905 |
Panasonic |
Switching Regulator Controller | |
3 | AN5010 |
ETC |
TV ELECTRONIC CHANNEL SELECTION CIRCUIT | |
4 | AN5011 |
Matsushita Electric |
TV Electronic Channel Selection Circuit | |
5 | AN502 |
AVIAQUIP |
SCREW - MACHINE / DRILLED FILLISTER HEAD / FINE THREAD | |
6 | AN5025K |
Panasonic |
Remote Control Receiver | |
7 | AN5026K |
Panasonic |
Remote Control Receiver | |
8 | AN503 |
Aviaquip |
Screw - Machine | |
9 | AN5033 |
Panasonic |
TV TUNING CONTROLLER | |
10 | AN5043SC |
Panasonic |
TV-Tuner Band Switch | |
11 | AN507 |
ETC |
SCREW | |
12 | AN5071 |
Panasonic Semiconductor |
TV Tuner Band-Switch |