TheA1184 device is a standard, two-wire, unipolar, Hall effect switch. The operate point, BOP, can be field-programmed, after final packaging of the device and placement into the application. This advanced feature allows the optimization of the device switching performance, by effectively accounting for variations caused by mounting tolerances for the device.
▪ Chopper stabilization ▫ Low switchpoint drift over operating temperature range ▫ Low sensitivity to stress ▪ Field programmable for optimized switchpoints ▪ On-chip protection ▫ Supply transient protection ▫ Reverse-battery protection ▫ On-board voltage regulator ▫ 3.5 to 24 V operation Packages: 3 pin SOT23W (suffix LH), and 3 pin SIP (suffix UA) Description TheA1184 device is a standard, two-wire, unipolar, Hall effect switch. The operate point, BOP, can be field-programmed, after final packaging of the device and placement into the application. This advanced feature allows the optimizati.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | A1180 |
Allegro MicroSystems |
Unipolar Hall-Effect Switch | |
2 | A1181 |
Allegro MicroSystems |
Unipolar Hall-Effect Switch | |
3 | A1182 |
Allegro MicroSystems |
Unipolar Hall-Effect Switch | |
4 | A1182 |
Toshiba |
2SA1182 | |
5 | A11820 |
THICK FILM |
RES NTWK | |
6 | A11820 |
Fenghua Advanced Technology |
RES NTWK / THICK FILM | |
7 | A1183 |
Allegro MicroSystems |
Unipolar Hall-Effect Switch | |
8 | A1185 |
Allegro MicroSystems |
Unipolar Hall-Effect Switches | |
9 | A1186 |
Allegro MicroSystems |
Unipolar Hall-Effect Switches | |
10 | A1101 |
Allegro MicroSystems |
Continuous-Time Switch | |
11 | A1102 |
Allegro MicroSystems |
Continuous-Time Switch | |
12 | A1102P |
Sony |
Dolby-B Type Noise Reduction System |