of the general procedure for assigning parameters to analog modules in Section 4.7. You will find an overview of the programmable parameters and their default values in Table 4-42, on page 4-47. 4-174 S7-300 Programmable Controller Module Specifications A5E00105505-02 Analog Modules Assigning parameters to channels You can configure each output channel o.
S S 4 outputs in 4 channel groups
12 bits has the following characteristic
The individual output channels can be programmed as
– Voltage outputs
– Current outputs
S S S S S
Resolution 12 bits Programmable diagnostics Programmable diagnostic interrupt Programmable substitute value output Isolated against backplane bus interface and load voltage
S7-300 Programmable Controller Module Specifications A5E00105505-02
4-171
Analog Modules
Terminal connection and block diagram of analog output module SM 332; AO 4 12 bits
Fault indicator
– red
Current output L+
Internal supply
Voltage output.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | 6ES7332-5HB01-0AB0 |
Siemens |
Analog Output Module | |
2 | 6ES7-332-5HD01-0AB0 |
Simatic |
S7-300/M7-300 Programmable Controllers Module | |
3 | 6ES7-332-5HD01-0AB0 |
Simatic |
S7-300 Analog Input/Output Modules | |
4 | 6ES72xxxxxx |
Siemens |
Central Processing Units | |
5 | 6ES72xxxxxx |
ETC |
Programmable Controller System Manual | |
6 | 6ES8 |
RCA |
Twin Triode | |
7 | 6E5 |
RFT |
Tube | |
8 | 6E5 |
RCA |
Tube | |
9 | 6E5 |
RCA |
Triode | |
10 | 6E5 |
ETC |
Triode Indicator | |
11 | 6EA8 |
GE |
Triode-Pentode | |
12 | 6EA8 |
RCA |
Triode Sharp-Cutoff Pentode |