The SA25F005 is a 512Kb (256K X 2) CMOS non-volatile serial Flash Memory. This device fully conforms to the SPI 4-wire protocol, is enabled through the Chip Select (CSb) pin, and uses Clock (SCK), Data-in (SI) and Data-out (SO) pins to synchronously control data transfer between the SPI microcontroller and the Serial FLASH memory. The memory can be programme.
•=
•=
•= Saifun NROM™ Flash Cell Serial Peripheral Interface (SPI) Compatible, Supports SPI Modes 0 (0,0) and 3 (1,1) Page Program Operation: 256 pages (256 Bytes/Page) Single Page Rewrite Cycle (Erase and Program) in 10ms Typical Page Program Mode (up to 256 bytes) in 9ms Typical Page Erase (256 bytes) in 3 ms Sector Erase (256 Kb) in 0.3 s Bulk Erase (512 Kb) Single Supply Voltage: 2.7 V to 3.6 V 25MHz Clock Rate Block Write Protection: Protect Quarter, Half or Entire Array Write Protect Pin and Write Disable Instructions of Both Hardware and Software Data Protection 100,000 Erase Cycles (Mi.
No. | Partie # | Fabricant | Description | Fiche Technique |
---|---|---|---|---|
1 | 25F1024AN |
ATMEL |
AT25F1024AN | |
2 | 25F40 |
International Rectifier |
STANDARD RECOVERY DIODES | |
3 | 25F40 |
Vishay Siliconix |
Standard Recovery Diodes | |
4 | 25F512 |
ATMEL Corporation |
AT25F512 | |
5 | 25F512AN |
ATMEL Corporation |
AT25F512AN | |
6 | 25F80 |
International Rectifier |
STANDARD RECOVERY DIODES | |
7 | 25F80 |
Vishay Siliconix |
Standard Recovery Diodes | |
8 | 25FE102K |
maida |
Zinc Oxide Varistor | |
9 | 25FE112K |
maida |
Zinc Oxide Varistor | |
10 | 25FE122K |
maida |
Zinc Oxide Varistor | |
11 | 25FE151K |
maida |
Zinc Oxide Varistor | |
12 | 25FE181K |
maida |
Zinc Oxide Varistor |